[PATCH] powerpc/powernv: Clear LPCR[PECE1] via stop-api only for deep state offline

[Akshay Adiga]

Hi Michael,

Any comments on this patch ?

On 09/06/2017 02:32 PM, pavrampu wrote:
> On 2017-08-31 17:17, Gautham R. Shenoy wrote:
> > From: "Gautham R. Shenoy" <ego at linux.vnet.ibm.com>
> >
> > commit 24be85a23d1f ("powerpc/powernv: Clear PECE1 in LPCR via
> > stop-api only on Hotplug") clears the PECE1 bit of the LPCR via
> > stop-api during CPU-Hotplug to prevent wakeup due to a decrementer on
> > an offlined CPU which is in a deep stop state.
> >
> > In the case where the stop-api support is found to be lacking, the
> > commit 785a12afdb4a ("powerpc/powernv/idle: Disable LOSE_FULL_CONTEXT
> > states when stop-api fails") disables deep states that lose hypervisor
> > context. Thus in this case, the offlined CPU will be put to some
> > shallow idle state.
> >
> > However, we currently unconditionally clear the PECE1 in LPCR via
> > stop-api during CPU-Hotplug even when deep states are disabled due to
> > stop-api failure.
> >
> > Fix this by clearing PECE1 of LPCR via stop-api during CPU-Hotplug
> > *only* when the offlined CPU will be put to a deep state that loses
> > hypervisor context.
> >
> > Fixes: commit 24be85a23d1f ("powerpc/powernv: Clear PECE1 in LPCR via
> > stop-api only on Hotplug")
> >
> > Reported-by: Pavithra Prakash <pavirampu at linux.vnet.ibm.com>
> > Signed-off-by: Gautham R. Shenoy <ego at linux.vnet.ibm.com>
>
> Tested-by: Pavithra Prakash <pavrampu at linux.vnet.ibm.com>
>
> > ---
> >  arch/powerpc/platforms/powernv/idle.c | 8 +++++++-
> >  1 file changed, 7 insertions(+), 1 deletion(-)
> >
> > diff --git a/arch/powerpc/platforms/powernv/idle.c
> > b/arch/powerpc/platforms/powernv/idle.c
> > index 9f59041..23f8fba 100644
> > --- a/arch/powerpc/platforms/powernv/idle.c
> > +++ b/arch/powerpc/platforms/powernv/idle.c
> > @@ -393,7 +393,13 @@ static void pnv_program_cpu_hotplug_lpcr(unsigned
> > int cpu, u64 lpcr_val)
> >      u64 pir = get_hard_smp_processor_id(cpu);
> >
> >      mtspr(SPRN_LPCR, lpcr_val);
> > -    opal_slw_set_reg(pir, SPRN_LPCR, lpcr_val);
> > +
> > +    /*
> > +     * Program the LPCR via stop-api only for deepest stop state
> > +     * can lose hypervisor context.
> > +     */
> > +    if (supported_cpuidle_states & OPAL_PM_LOSE_FULL_CONTEXT)
> > +        opal_slw_set_reg(pir, SPRN_LPCR, lpcr_val);
> >  }
> >
> >  /*