[PATCH] powerpc/xmon: Fix an unexpected xmon onoff state change

[Guilherme G. Piccoli]

On 15/02/2017 05:49, Pan Xinhui wrote:
> Once xmon is triggered by sysrq-x, it is enabled always afterwards even
> if it is disabled during boot. This will cause a system reset interrut
> fail to dump. So keep xmon in its original state after exit.
> 
> Signed-off-by: Pan Xinhui <xinhui.pan at linux.vnet.ibm.com>

Patch is fine - minor typo: interrut => interrupt

Feel free to add my:
Tested-by: Guilherme G. Piccoli <gpiccoli at linux.vnet.ibm.com>

Thanks,


Guilherme

> ---
>  arch/powerpc/xmon/xmon.c | 5 ++++-
>  1 file changed, 4 insertions(+), 1 deletion(-)
> 
> diff --git a/arch/powerpc/xmon/xmon.c b/arch/powerpc/xmon/xmon.c
> index 9c0e17c..721212f 100644
> --- a/arch/powerpc/xmon/xmon.c
> +++ b/arch/powerpc/xmon/xmon.c
> @@ -76,6 +76,7 @@ static int xmon_gate;
>  #endif /* CONFIG_SMP */
> 
>  static unsigned long in_xmon __read_mostly = 0;
> +static int xmon_off = 0;
> 
>  static unsigned long adrs;
>  static int size = 1;
> @@ -3250,6 +3251,8 @@ static void sysrq_handle_xmon(int key)
>  	/* ensure xmon is enabled */
>  	xmon_init(1);
>  	debugger(get_irq_regs());
> +	if (xmon_off)
> +		xmon_init(0);
>  }
> 
>  static struct sysrq_key_op sysrq_xmon_op = {
> @@ -3266,7 +3269,7 @@ static int __init setup_xmon_sysrq(void)
>  __initcall(setup_xmon_sysrq);
>  #endif /* CONFIG_MAGIC_SYSRQ */
> 
> -static int __initdata xmon_early, xmon_off;
> +static int __initdata xmon_early;
> 
>  static int __init early_parse_xmon(char *p)
>  {
>