[v6,2/2] QE: remove PPCisms for QE

[Qiang Zhao]

On Tue, Sep 27, 2016 at 7:12AM -0500, Scott Wood wrote:

> -----Original Message-----
> From: Scott Wood [mailto:oss at buserror.net]
> Sent: Tuesday, September 27, 2016 7:12 AM
> To: Qiang Zhao <qiang.zhao at nxp.com>
> Cc: linuxppc-dev at lists.ozlabs.org; pku.leo at gmail.com; X.B. Xie
> <xiaobo.xie at nxp.com>; linux-kernel at vger.kernel.org
> Subject: Re: [v6,2/2] QE: remove PPCisms for QE
> 
> On Mon, 2016-09-26 at 01:46 +0000, Qiang Zhao wrote:
> > On Sun, Sep 25, 2016 at 12:19PM -0500, Scott Wood wrote:
> >
> > >
> > > -----Original Message-----
> > > From: Scott Wood [mailto:oss at buserror.net]
> > > Sent: Sunday, September 25, 2016 12:19 PM
> > > To: Qiang Zhao <qiang.zhao at nxp.com>
> > > Cc: linuxppc-dev at lists.ozlabs.org; pku.leo at gmail.com; X.B. Xie
> > > <xiaobo.xie at nxp.com>; linux-kernel at vger.kernel.org
> > > Subject: Re: [v6,2/2] QE: remove PPCisms for QE
> > >
> > > On Sat, Sep 24, 2016 at 11:14:11PM -0500, Scott Wood wrote:
> > > >
> > > > On Fri, Sep 23, 2016 at 10:20:32AM +0800, Zhao Qiang wrote:
> > > > >
> > > > > QE was supported on PowerPC, and dependent on PPC, Now it is
> > > > > supported on other platforms. so remove PPCisms.
> > > > >
> > > > > Signed-off-by: Zhao Qiang <qiang.zhao at nxp.com>
> > > > > ---
> > > > > Changes for v2:
> > > > > 	- na
> > > > > Changes for v3:
> > > > > 	- add NO_IRQ
> > > > > Changes for v4:
> > > > > 	- modify spin_event_timeout to opencoded timeout loop
> > > > > 	- remove NO_IRQ
> > > > > 	- modify virq_to_hw to opencoed code Changes for v5:
> > > > > 	- modify commit msg
> > > > > 	- modify depends of QUICC_ENGINE
> > > > > 	- add kerneldoc header for qe_issue_cmd Changes for v6:
> > > > > 	- add dependency on FSL_SOC and PPC32 for drivers
> > > > > 	  depending on QUICC_ENGING but not available on ARM
> > > > >
> > > > >  drivers/irqchip/qe_ic.c                | 28 +++++++-----
> > > > >  drivers/net/ethernet/freescale/Kconfig | 10 ++---
> > > > >  drivers/soc/fsl/qe/Kconfig             |  2 +-
> > > > >  drivers/soc/fsl/qe/qe.c                | 80
> > > > > ++++++++++++++++++++-----
> > > > > ---------
> > > > >  drivers/soc/fsl/qe/qe_io.c             | 42 ++++++++----------
> > > > >  drivers/soc/fsl/qe/qe_tdm.c            |  8 ++--
> > > > >  drivers/soc/fsl/qe/ucc.c               | 10 ++---
> > > > >  drivers/soc/fsl/qe/ucc_fast.c          | 68
> > > > > ++++++++++++++-----------
> > > > > ----
> > > > >  drivers/tty/serial/Kconfig             |  2 +-
> > > > >  drivers/usb/gadget/udc/Kconfig         |  2 +-
> > > > >  drivers/usb/host/Kconfig               |  2 +-
> > > > >  include/soc/fsl/qe/qe.h                |  1 -
> > > > >  include/soc/fsl/qe/qe_ic.h             | 12 ++---
> > > > >  13 files changed, 141 insertions(+), 126 deletions(-)
> > > > I assume this means you'll be updating
> > > > http://patchwork.ozlabs.org/patch/654473/
> > > > to be based on top of this...
> > > Apparently that assumption was wrong, since I now see that you're
> > > patching drivers/irqchip/qe_ic.c rather than drivers/soc/fsl/qe/qe_ic.c.
> > > Please keep the drivers/irqchip stuff separate and send to the
> > > appropriate maintainers.
> > >
> > You means separate drivers/irqchip/qe_ic.c part from this patch and
> > send it with the other qe_ic patches?
> > Is it acceptable if I modify qe_ic.c with drivers/soc/fsl/qe/qe_ic.c,
> > then send qe_ic patches to move qe_ic to drivers/irqchip?
> 
> I'd recommend against it.  It would complicate getting the drivers/irqchip
> patchset merged.  In any case, it's too late for 4.9.

Ok, thank you for your recommend.

BR
-Zhao Qiang