[PATCH 5/5] vfio-pci: Allow to mmap MSI-X table if interrupt remapping is supported

Alex Williamson alex.williamson at redhat.com
Thu May 12 12:20:42 AEST 2016


On Thu, 12 May 2016 01:19:44 +0000
"Tian, Kevin" <kevin.tian at intel.com> wrote:

> > From: Alex Williamson [mailto:alex.williamson at redhat.com]
> > Sent: Wednesday, May 11, 2016 11:54 PM
> > 
> > On Wed, 11 May 2016 06:29:06 +0000
> > "Tian, Kevin" <kevin.tian at intel.com> wrote:
> >   
> > > > From: Alex Williamson [mailto:alex.williamson at redhat.com]
> > > > Sent: Thursday, May 05, 2016 11:05 PM
> > > >
> > > > On Thu, 5 May 2016 12:15:46 +0000
> > > > "Tian, Kevin" <kevin.tian at intel.com> wrote:
> > > >  
> > > > > > From: Yongji Xie [mailto:xyjxie at linux.vnet.ibm.com]
> > > > > > Sent: Thursday, May 05, 2016 7:43 PM
> > > > > >
> > > > > > Hi David and Kevin,
> > > > > >
> > > > > > On 2016/5/5 17:54, David Laight wrote:
> > > > > >  
> > > > > > > From: Tian, Kevin  
> > > > > > >> Sent: 05 May 2016 10:37  
> > > > > > > ...  
> > > > > > >>> Acutually, we are not aimed at accessing MSI-X table from
> > > > > > >>> guest. So I think it's safe to passthrough MSI-X table if we
> > > > > > >>> can make sure guest kernel would not touch MSI-X table in
> > > > > > >>> normal code path such as para-virtualized guest kernel on PPC64.
> > > > > > >>>  
> > > > > > >> Then how do you prevent malicious guest kernel accessing it?  
> > > > > > > Or a malicious guest driver for an ethernet card setting up
> > > > > > > the receive buffer ring to contain a single word entry that
> > > > > > > contains the address associated with an MSI-X interrupt and
> > > > > > > then using a loopback mode to cause a specific packet be
> > > > > > > received that writes the required word through that address.
> > > > > > >
> > > > > > > Remember the PCIe cycle for an interrupt is a normal memory write
> > > > > > > cycle.
> > > > > > >
> > > > > > > 	David
> > > > > > >  
> > > > > >
> > > > > > If we have enough permission to load a malicious driver or
> > > > > > kernel, we can easily break the guest without exposed
> > > > > > MSI-X table.
> > > > > >
> > > > > > I think it should be safe to expose MSI-X table if we can
> > > > > > make sure that malicious guest driver/kernel can't use
> > > > > > the MSI-X table to break other guest or host. The
> > > > > > capability of IRQ remapping could provide this
> > > > > > kind of protection.
> > > > > >  
> > > > >
> > > > > With IRQ remapping it doesn't mean you can pass through MSI-X
> > > > > structure to guest. I know actual IRQ remapping might be platform
> > > > > specific, but at least for Intel VT-d specification, MSI-X entry must
> > > > > be configured with a remappable format by host kernel which
> > > > > contains an index into IRQ remapping table. The index will find a
> > > > > IRQ remapping entry which controls interrupt routing for a specific
> > > > > device. If you allow a malicious program random index into MSI-X
> > > > > entry of assigned device, the hole is obvious...
> > > > >
> > > > > Above might make sense only for a IRQ remapping implementation
> > > > > which doesn't rely on extended MSI-X format (e.g. simply based on
> > > > > BDF). If that's the case for PPC, then you should build MSI-X
> > > > > passthrough based on this fact instead of general IRQ remapping
> > > > > enabled or not.  
> > > >
> > > > I don't think anyone is expecting that we can expose the MSI-X vector
> > > > table to the guest and the guest can make direct use of it.  The end
> > > > goal here is that the guest on a power system is already
> > > > paravirtualized to not program the device MSI-X by directly writing to
> > > > the MSI-X vector table.  They have hypercalls for this since they
> > > > always run virtualized.  Therefore a) they never intend to touch the
> > > > MSI-X vector table and b) they have sufficient isolation that a guest
> > > > can only hurt itself by doing so.
> > > >
> > > > On x86 we don't have a), our method of programming the MSI-X vector
> > > > table is to directly write to it. Therefore we will always require QEMU
> > > > to place a MemoryRegion over the vector table to intercept those
> > > > accesses.  However with interrupt remapping, we do have b) on x86, which
> > > > means that we don't need to be so strict in disallowing user accesses
> > > > to the MSI-X vector table.  It's not useful for configuring MSI-X on
> > > > the device, but the user should only be able to hurt themselves by
> > > > writing it directly.  x86 doesn't really get anything out of this
> > > > change, but it helps this special case on power pretty significantly
> > > > aiui.  Thanks,
> > > >  
> > >
> > > Allowing guest direct write to MSI-x table has system-wide impact.
> > > As I explained earlier, hypervisor needs to control "interrupt_index"
> > > programmed in MSI-X entry, which is used to associate a specific
> > > IRQ remapping entry. Now if you expose whole MSI-x table to guest,
> > > it can program random index into MSI-X entry to associate with
> > > any IRQ remapping entry and then there won't be any isolation per se.
> > >
> > > You can check "5.5.2 MSI and MSI-X Register Programming" in VT-d
> > > spec.  
> > 
> > I think you're extrapolating beyond the vfio interface.  The change
> > here is to remove the vfio protection of the MSI-X vector table when
> > the system provides interrupt isolation.  The argument is that this is
> > safe to do because the hardware protects the host from erroneous and
> > malicious user programming, but it is not meant to provide a means to
> > program MSI-X directly through the vector table.  This is effectively  
> 
> Sorry I didn't get this point. Once we allow userspace to mmap MSI-X
> table, isn't it equivalent to allowing userspace directly program vector
> table? Or is there other mechanism to prevent direct programming?

This would remove the mechanism that prevents direct programming.
Users can configure the device to perform DMA w/o setting up an IOMMU
mapping, which generates a fault.  Users can incorrectly manipulate the
MSI-X vector table instead of using the proper vfio programming
interface, which generates a fault.

> > the same as general DMA programming, if the vfio programming model is
> > not followed the device generates iommu faults.  I do have a concern
> > that userspace driver writers are going to more often presume they can
> > use the vector table directly because of this change, but I don't know
> > that that is sufficient reason to prevent such a change.  They'll
> > quickly discover the device generates faults on interrupt rather than
> > working as expected.  
> 
> If userspace can actually program vector table directly, there is not
> always fault triggered. As long as MSI-X table is fully under control
> of userspace, any interrupt index can be used here which may link
> to a IRQ remapping entry allocated for other devices.

Is not part of the vector lookup comparing the source ID of the DMA
write?  If not then VT-d interrupt remapping offers us no protection
from a malicious guest performing DMA to the same address.  Thanks,

Alex


More information about the Linuxppc-dev mailing list