[v6, 3/5] dt: move guts devicetree doc out of powerpc directory

Scott Wood scott.wood at nxp.com
Sat Mar 19 05:16:06 AEDT 2016


On 03/17/2016 12:06 PM, Rob Herring wrote:
> On Wed, Mar 09, 2016 at 06:08:49PM +0800, Yangbo Lu wrote:
>> Move guts devicetree doc to Documentation/devicetree/bindings/soc/fsl/
>> since it's used by not only PowerPC but also ARM. And add a specification
>> for 'little-endian' property.
>>
>> Signed-off-by: Yangbo Lu <yangbo.lu at nxp.com>
>> ---
>> Changes for v2:
>> 	- None
>> Changes for v3:
>> 	- None
>> Changes for v4:
>> 	- Added this patch
>> Changes for v5:
>> 	- Modified the description for little-endian property
>> Changes for v6:
>> 	- None
>> ---
>>  Documentation/devicetree/bindings/{powerpc => soc}/fsl/guts.txt | 3 +++
>>  1 file changed, 3 insertions(+)
>>  rename Documentation/devicetree/bindings/{powerpc => soc}/fsl/guts.txt (91%)
>>
>> diff --git a/Documentation/devicetree/bindings/powerpc/fsl/guts.txt b/Documentation/devicetree/bindings/soc/fsl/guts.txt
>> similarity index 91%
>> rename from Documentation/devicetree/bindings/powerpc/fsl/guts.txt
>> rename to Documentation/devicetree/bindings/soc/fsl/guts.txt
>> index b71b203..07adca9 100644
>> --- a/Documentation/devicetree/bindings/powerpc/fsl/guts.txt
>> +++ b/Documentation/devicetree/bindings/soc/fsl/guts.txt
>> @@ -25,6 +25,9 @@ Recommended properties:
>>   - fsl,liodn-bits : Indicates the number of defined bits in the LIODN
>>     registers, for those SOCs that have a PAMU device.
>>  
>> + - little-endian : Indicates that the global utilities block is little
>> +   endian. The default is big endian.
> 
> The default is "the native endianness of the system". So absence on an 
> ARM system would be LE.

No.  For this binding, the default is big-endian, because that's what
existed for this device before an endian property was added.

"endianness of the system" is not a well-defined concept.

> This property is valid for any simple-bus device, 

Since when does simple-bus mean anything more than that the nodes
underneath it can be used without bus-specific knowledge?

> so it isn't really required to document per device. You can, but 
> your description had better match the documented behaviour.

Documented where?

In fact, Documentation/devicetree/bindings/common-properties.txt
explicitly says of the endian properties, "If a binding supports these
properties, then the binding should also specify the default behavior if
none of these properties are present."

-Scott



More information about the Linuxppc-dev mailing list