[PATCH 1/3][v2] net: phy: introduce 1000BASE-KX and 10GBASE-KR

[Andrew Lunn]

On Tue, Jan 19, 2016 at 05:00:35AM +0000, Shaohui Xie wrote:
> > -----Original Message-----
> > From: Andrew Lunn [mailto:andrew at lunn.ch]
> > Sent: Monday, January 18, 2016 11:15 PM
> > To: Shaohui Xie
> > Cc: Sebastian Hesselbarth; Florian Fainelli; shh.xie at gmail.com;
> > devicetree at vger.kernel.org; netdev at vger.kernel.org; linuxppc-
> > dev at lists.ozlabs.org; davem at davemloft.net; Shaohui Xie
> > Subject: Re: [PATCH 1/3][v2] net: phy: introduce 1000BASE-KX and 10GBASE-KR
> > 
> > > [S.H] the fsl backplane, e.g. 10GBASE-KR, needs software to handle
> > > link training, It's to train link partner, and trained by link partner
> > parallel.
> > >
> > > But if media type is not copper, e.g. optical module, we won't need this.
> > 
> > So what we actually need to know is copper vs fibre?

> Copper is not enough to indicate backplane, since backplane is
> always copper, but copper is not always backplane.

O.K, lets try again....

If it is copper backplane you need to perform training.

Looking at the driver probe function, it is either 1000BASE-KX, no
training needed, or else it is 10GBASE-RK and training is needed.

Looking at fsl_backplane_config_aneg() you expect phydev->speed to be
set, and from the speed you then kick of either KR autoneg or KX
autoneg. Could you also start the training at this point? Use the
speed to indicate if training is needed?

      Andrew