[PATCH 2/3] [v2] powerpc: fsl: update fman dt binding for PCS PHY

[Rob Herring]

On Thu, Jan 14, 2016 at 04:27:18PM +0800, shh.xie at gmail.com wrote:
> From: Shaohui Xie <Shaohui.Xie at freescale.com>
> 
> PCS PHY can support backplane (1000BASE-KX and 10GBASE-KR), this needs
> to change corresponding serdes lane settings, so a reference is needed
> for serdes lane. This patch describes properties needed for PCS PHY to
> support backplane.
> 
> Signed-off-by: Shaohui Xie <Shaohui.Xie at freescale.com>
> ---
> changes in v2:
> addressed Rob's comments.
> based on http://patchwork.ozlabs.org/patch/560936/
> 
>  Documentation/devicetree/bindings/powerpc/fsl/fman.txt | 14 ++++++++++++++
>  1 file changed, 14 insertions(+)
> 
> diff --git a/Documentation/devicetree/bindings/powerpc/fsl/fman.txt b/Documentation/devicetree/bindings/powerpc/fsl/fman.txt
> index 55c2c03..5ca909a 100644
> --- a/Documentation/devicetree/bindings/powerpc/fsl/fman.txt
> +++ b/Documentation/devicetree/bindings/powerpc/fsl/fman.txt
> @@ -432,6 +432,16 @@ example of how to define a PHY (Internal PHY has no interrupt line).
>  - For "fsl,fman-mdio" compatible internal mdio bus, the PHY is TBI PHY.
>  - For "fsl,fman-memac-mdio" compatible internal mdio bus, the PHY is PCS PHY,
>    PCS PHY addr must be '0'.
> +  PCS PHY can support backplane (1000BASE-KX and 10GBASE-KR), this needs to
> +  change the corresponding serdes lane settings.
> +
> +  PCS PHY node properties required for backplane:
> +
> +  - compatible: must be "ethernet-phy-ieee802.3-c45".
> +  - phy-mode: string, operation mode of the PHY interface; must be "1000base-kx"
> +    for 1000BASE-KX, or "10gbase-kr" for 10GBASE-KR.
> +  - fsl-lane-handle: phandle, specifies a reference to a node representing a Serdes.
> +  - fsl-lane-reg: offset and length of the register set for the serdes lane.

These should be fsl,... not fsl-...

Rob