[alsa-devel] Setting some clocks back to DUMMY fixes spdif output on imx6q wandboard rev B1

Xavi Drudis Ferran xdrudis at tinet.cat
Wed Aug 31 23:49:25 AEST 2016


El Wed, Aug 31, 2016 at 10:11:13AM -0300, Fabio Estevam deia:
> 2. SPDIF clock rate not accurate. Probably using PLL4 as SPDIF source
> would help to get more accurate SPDIF clock rates.
> 
> Could you please try the untested change?
> 
> --- a/drivers/clk/imx/clk-imx6q.c
> +++ b/drivers/clk/imx/clk-imx6q.c
> @@ -623,7 +623,7 @@ static void __init imx6q_clocks_init(struct
> device_node *ccm_node)
>                 pr_warn("failed to set up CLKO: %d\n", ret);
> 
>         /* Audio-related clocks configuration */
> -       clk_set_parent(clk[IMX6QDL_CLK_SPDIF_SEL],
> clk[IMX6QDL_CLK_PLL3_PFD3_454M]);
> +       clk_set_parent(clk[IMX6QDL_CLK_SPDIF_SEL],
> clk[IMX6QDL_CLK_PLL4_AUDIO_DIV]);
> 
>         /* All existing boards with PCIe use LVDS1 */
>         if (IS_ENABLED(CONFIG_PCI_IMX6))
>

I'm going to try. I'll take a while. I'll report the result later.

Thank you very much.


More information about the Linuxppc-dev mailing list