[PATCH v2 22/30] cxlflash: Correct behavior in device reset handler following EEH

[Matthew R. Ochs]

When the device reset handler is entered while a reset operation
is taking place, the handler exits without actually sending a
reset (TMF) to the targeted device. This behavior is incorrect
as the device is not reset. Further complicating matters is the
fact that a success is returned even when the TMF was not sent.

To fix, the state is rechecked after coming out of the reset
state. When the state is normal, a TMF will be sent out.

Signed-off-by: Matthew R. Ochs <mrochs at linux.vnet.ibm.com>
Signed-off-by: Manoj N. Kumar <manoj at linux.vnet.ibm.com>
Suggested-by: Brian King <brking at linux.vnet.ibm.com>
---
 drivers/scsi/cxlflash/main.c | 5 ++---
 1 file changed, 2 insertions(+), 3 deletions(-)

diff --git a/drivers/scsi/cxlflash/main.c b/drivers/scsi/cxlflash/main.c
index 1625aea..922fac7 100644
--- a/drivers/scsi/cxlflash/main.c
+++ b/drivers/scsi/cxlflash/main.c
@@ -1931,6 +1931,7 @@ static int cxlflash_eh_device_reset_handler(struct scsi_cmnd *scp)
 		 get_unaligned_be32(&((u32 *)scp->cmnd)[2]),
 		 get_unaligned_be32(&((u32 *)scp->cmnd)[3]));
 
+retry:
 	switch (cfg->state) {
 	case STATE_NORMAL:
 		rcr = send_tmf(afu, scp, TMF_LUN_RESET);
@@ -1939,9 +1940,7 @@ static int cxlflash_eh_device_reset_handler(struct scsi_cmnd *scp)
 		break;
 	case STATE_RESET:
 		wait_event(cfg->reset_waitq, cfg->state != STATE_RESET);
-		if (cfg->state == STATE_NORMAL)
-			break;
-		/* fall through */
+		goto retry;
 	default:
 		rc = FAILED;
 		break;
-- 
2.1.0