[PATCH] powerpc/eeh: eeh_pci_enable(): fix checking of post-request state

[Andrew Donnellan]

In eeh_pci_enable(), after making the request to set the new options, we
call eeh_ops->wait_state() to check that the request finished successfully.

At the moment, if eeh_ops->wait_state() returns 0, we return 0 without
checking that it reflects the expected outcome. This can lead to callers
further up the chain incorrectly assuming the slot has been successfully
unfrozen and continuing to attempt recovery.

On powernv, this will occur if pnv_eeh_get_pe_state() or
pnv_eeh_get_phb_state() return 0, which in turn occurs if the relevant OPAL
call returns OPAL_EEH_STOPPED_MMIO_DMA_FREEZE or
OPAL_EEH_PHB_ERROR respectively.

On pseries, this will occur if pseries_eeh_get_state() returns 0, which in
turn occurs if RTAS reports that the PE is in the MMIO Stopped and DMA
Stopped states.

Obviously, none of these cases represent a successful completion of a
request to thaw MMIO or DMA.

Fix the check so that a wait_state() return value of 0 won't be considered
successful for the EEH_OPT_THAW_MMIO or EEH_OPT_THAW_DMA cases.

Cc: Gavin Shan <gwshan at linux.vnet.ibm.com>
Signed-off-by: Andrew Donnellan <andrew.donnellan at au1.ibm.com>
---
 arch/powerpc/kernel/eeh.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/arch/powerpc/kernel/eeh.c b/arch/powerpc/kernel/eeh.c
index 40e4d4a..d757e7c 100644
--- a/arch/powerpc/kernel/eeh.c
+++ b/arch/powerpc/kernel/eeh.c
@@ -677,7 +677,7 @@ int eeh_pci_enable(struct eeh_pe *pe, int function)
 	/* Check if the request is finished successfully */
 	if (active_flag) {
 		rc = eeh_ops->wait_state(pe, PCI_BUS_RESET_WAIT_MSEC);
-		if (rc <= 0)
+		if (rc < 0)
 			return rc;
 
 		if (rc & active_flag)
-- 
Andrew Donnellan              Software Engineer, OzLabs
andrew.donnellan at au1.ibm.com  Australia Development Lab, Canberra
+61 2 6201 8874 (work)        IBM Australia Limited