[PATCH] powerpc/cell: Remove the Cell QPACE code.

[Michael Ellerman]

On Thu, 2015-11-26 at 13:39 +0100, Thomas Huth wrote:
> On 26/11/15 13:09, Michael Ellerman wrote:
> > On Thu, 2015-11-26 at 11:47 +0100, Thomas Huth wrote:
> > > On 26/11/15 01:59, Rashmica Gupta wrote:
> > > > All users of QPACE have upgraded to QPACE2 so remove the Cell QPACE code.
> > > > 
> > > > Signed-off-by: Rashmica Gupta <rashmicy at gmail.com>
> > > > ---
> > > >  arch/powerpc/boot/Makefile                |   2 -
> > > >  arch/powerpc/configs/ppc64_defconfig      |   1 -
> > > >  arch/powerpc/platforms/cell/Kconfig       |   5 -
> > > >  arch/powerpc/platforms/cell/Makefile      |   3 -
> > > >  arch/powerpc/platforms/cell/qpace_setup.c | 148 ------------------------------
> > > >  5 files changed, 159 deletions(-)
> > > >  delete mode 100644 arch/powerpc/platforms/cell/qpace_setup.c
> > > 
> > > There one more reference to qpace in the file
> > >  Documentation/devicetree/bindings/serial/8250.txt
> > > ... you might want to remove that, too.
> > 
> > There's also one in drivers/tty/serial/of_serial.c.
> > 
> > Arnd said he already had a patch to remove those, not sure if he's sent it
> > though.
> 
> He apparently did:
> 
>  https://lkml.org/lkml/2015/11/16/454
> 
> So the change to the file in Documentation should ideally go also into
> his patch instead, I think.

Ah thanks for checking.

OK agreed.

Rashmica can you send a v2 with the reference in Documentation removed, thanks.

cheers