[PATCH] powerpc/85xx: p1025twr: add module conditional to fix QE-uart issue

[Scott Wood]

On Thu, 2015-04-30 at 10:56 +0800, Pengbo Li wrote:
> From: Xie Xiaobo <X.Xie at freescale.com>
> 
> A ioport setting was needed when used the QE uart function on TWR-P1025.
> Added a conditional definition to avoid missing this setting when the
> QE-uart driver was bulit to a module.

s/was bulit to/is built as/

> Signed-off-by: Xie Xiaobo <X.Xie at freescale.com>
> Change-Id: I95b40c760335ce5fa7a27a94287dbef28219b5fa
> Reviewed-on: http://git.am.freescale.net:8181/6643
> Tested-by: Review Code-CDREVIEW <CDREVIEW at freescale.com>
> Reviewed-by: Yang Li <LeoLi at freescale.com>
> Reviewed-by: Thomas Trefny <Tom.Trefny at freescale.com>
> Reviewed-on: http://git.am.freescale.net:8181/12045
> Reviewed-by: Jose Rivera <German.Rivera at freescale.com>
> ---
>  arch/powerpc/platforms/85xx/twr_p102x.c | 2 +-
>  1 file changed, 1 insertion(+), 1 deletion(-)
> 
> diff --git a/arch/powerpc/platforms/85xx/twr_p102x.c b/arch/powerpc/platforms/85xx/twr_p102x.c
> index 1eadb6d..069e19b 100644
> --- a/arch/powerpc/platforms/85xx/twr_p102x.c
> +++ b/arch/powerpc/platforms/85xx/twr_p102x.c
> @@ -101,7 +101,7 @@ static void __init twr_p1025_setup_arch(void)
>  					MPC85xx_PMUXCR_QE(12));
>  			iounmap(guts);
>  
> -#if defined(CONFIG_SERIAL_QE)
> +#if defined(CONFIG_SERIAL_QE) || defined(CONFIG_SERIAL_QE_MODULE)
>  			/* On P1025TWR board, the UCC7 acted as UART port.
>  			 * However, The UCC7's CTS pin is low level in default,
>  			 * it will impact the transmission in full duplex

How about using IS_ENABLED here?

Don't you need an equivalent change to
"#if defined(CONFIG_UCC_GETH) || defined(CONFIG_SERIAL_QE)"
?

Do we really need the ifdefs at all?  What's the harm in setting up the
pins if those things aren't built into the kernel?  Power consumption?
Is it a likely use case?

-Scott