[PATCH] tty: pr_warning->pr_warn and logging neatening
Joe Perches
joe at perches.com
Mon Nov 10 17:46:35 AEDT 2014
Convert the pr_warning to the more common pr_warn.
Other miscellanea:
o Convert unusual PR_FMT define and uses to pr_fmt
o Remove unnecessary OOM message
o Fix grammar in an error message
o Convert a pr_warning with a KERN_ERR to pr_err
Signed-off-by: Joe Perches <joe at perches.com>
---
drivers/tty/ehv_bytechan.c | 4 ++--
drivers/tty/hvc/hvcs.c | 2 +-
drivers/tty/isicom.c | 14 +++++++-------
drivers/tty/serial/bfin_sport_uart.c | 5 +++--
drivers/tty/serial/mfd.c | 2 +-
drivers/tty/serial/mrst_max3110.c | 27 ++++++++++++---------------
drivers/tty/vt/keyboard.c | 6 +++---
drivers/tty/vt/vt.c | 4 ++--
8 files changed, 31 insertions(+), 33 deletions(-)
diff --git a/drivers/tty/ehv_bytechan.c b/drivers/tty/ehv_bytechan.c
index 4f485e8..9d29d7e 100644
--- a/drivers/tty/ehv_bytechan.c
+++ b/drivers/tty/ehv_bytechan.c
@@ -309,8 +309,8 @@ static int __init ehv_bc_console_init(void)
* handle for udbg.
*/
if (stdout_bc != CONFIG_PPC_EARLY_DEBUG_EHV_BC_HANDLE)
- pr_warning("ehv-bc: udbg handle %u is not the stdout handle\n",
- CONFIG_PPC_EARLY_DEBUG_EHV_BC_HANDLE);
+ pr_warn("ehv-bc: udbg handle %u is not the stdout handle\n",
+ CONFIG_PPC_EARLY_DEBUG_EHV_BC_HANDLE);
#endif
/* add_preferred_console() must be called before register_console(),
diff --git a/drivers/tty/hvc/hvcs.c b/drivers/tty/hvc/hvcs.c
index 81e939e..00bec633 100644
--- a/drivers/tty/hvc/hvcs.c
+++ b/drivers/tty/hvc/hvcs.c
@@ -1575,7 +1575,7 @@ static int __init hvcs_module_init(void)
*/
rc = driver_create_file(&(hvcs_vio_driver.driver), &driver_attr_rescan);
if (rc)
- pr_warning(KERN_ERR "HVCS: Failed to create rescan file (err %d)\n", rc);
+ pr_err("HVCS: Failed to create rescan file (err %d)\n", rc);
return 0;
}
diff --git a/drivers/tty/isicom.c b/drivers/tty/isicom.c
index 858291c..59ed783 100644
--- a/drivers/tty/isicom.c
+++ b/drivers/tty/isicom.c
@@ -249,7 +249,7 @@ static int lock_card(struct isi_board *card)
spin_unlock_irqrestore(&card->card_lock, card->flags);
msleep(10);
}
- pr_warning("Failed to lock Card (0x%lx)\n", card->base);
+ pr_warn("Failed to lock Card (0x%lx)\n", card->base);
return 0; /* Failed to acquire the card! */
}
@@ -378,13 +378,13 @@ static inline int __isicom_paranoia_check(struct isi_port const *port,
char *name, const char *routine)
{
if (!port) {
- pr_warning("Warning: bad isicom magic for dev %s in %s.\n",
- name, routine);
+ pr_warn("Warning: bad isicom magic for dev %s in %s\n",
+ name, routine);
return 1;
}
if (port->magic != ISICOM_MAGIC) {
- pr_warning("Warning: NULL isicom port for dev %s in %s.\n",
- name, routine);
+ pr_warn("Warning: NULL isicom port for dev %s in %s\n",
+ name, routine);
return 1;
}
@@ -546,8 +546,8 @@ static irqreturn_t isicom_interrupt(int irq, void *dev_id)
byte_count = header & 0xff;
if (channel + 1 > card->port_count) {
- pr_warning("%s(0x%lx): %d(channel) > port_count.\n",
- __func__, base, channel+1);
+ pr_warn("%s(0x%lx): %d(channel) > port_count\n",
+ __func__, base, channel + 1);
outw(0x0000, base+0x04); /* enable interrupts */
spin_unlock(&card->card_lock);
return IRQ_HANDLED;
diff --git a/drivers/tty/serial/bfin_sport_uart.c b/drivers/tty/serial/bfin_sport_uart.c
index d62d8da..67d4083 100644
--- a/drivers/tty/serial/bfin_sport_uart.c
+++ b/drivers/tty/serial/bfin_sport_uart.c
@@ -517,14 +517,15 @@ static void sport_set_termios(struct uart_port *port,
up->csize = 5;
break;
default:
- pr_warning("requested word length not supported\n");
+ pr_warn("requested word length not supported\n");
+ break;
}
if (termios->c_cflag & CSTOPB) {
up->stopb = 1;
}
if (termios->c_cflag & PARENB) {
- pr_warning("PAREN bits is not supported yet\n");
+ pr_warn("PAREN bit is not supported yet\n");
/* up->parib = 1; */
}
diff --git a/drivers/tty/serial/mfd.c b/drivers/tty/serial/mfd.c
index 445799d..e1f4fda 100644
--- a/drivers/tty/serial/mfd.c
+++ b/drivers/tty/serial/mfd.c
@@ -1371,7 +1371,7 @@ static void hsu_global_init(void)
hsu->iolen = 0x1000;
if (!(request_mem_region(hsu->paddr, hsu->iolen, "HSU global")))
- pr_warning("HSU: error in request mem region\n");
+ pr_warn("HSU: error in request mem region\n");
hsu->reg = ioremap_nocache((unsigned long)hsu->paddr, hsu->iolen);
if (!hsu->reg) {
diff --git a/drivers/tty/serial/mrst_max3110.c b/drivers/tty/serial/mrst_max3110.c
index 1504a14..77239d5 100644
--- a/drivers/tty/serial/mrst_max3110.c
+++ b/drivers/tty/serial/mrst_max3110.c
@@ -27,6 +27,8 @@
* interrupt for a low speed UART device
*/
+#define pr_fmt(fmt) KBUILD_MODNAME ": " fmt
+
#ifdef CONFIG_MAGIC_SYSRQ
#define SUPPORT_SYSRQ
#endif
@@ -47,8 +49,6 @@
#include "mrst_max3110.h"
-#define PR_FMT "mrst_max3110: "
-
#define UART_TX_NEEDED 1
#define CON_TX_NEEDED 2
#define BIT_IRQ_PENDING 3
@@ -127,8 +127,8 @@ static int max3110_out(struct uart_max3110 *max, const u16 out)
*obuf = out;
ret = max3110_write_then_read(max, obuf, ibuf, 2, 1);
if (ret) {
- pr_warning(PR_FMT "%s(): get err msg %d when sending 0x%x\n",
- __func__, ret, out);
+ pr_warn("%s: get err msg %d when sending 0x%x\n",
+ __func__, ret, out);
goto exit;
}
@@ -153,10 +153,8 @@ static int max3110_read_multi(struct uart_max3110 *max)
blen = M3110_RX_FIFO_DEPTH * sizeof(u16);
buf = kzalloc(blen * 2, GFP_KERNEL | GFP_DMA);
- if (!buf) {
- pr_warning(PR_FMT "%s(): fail to alloc dma buffer\n", __func__);
+ if (!buf)
return 0;
- }
/* tx/rx always have the same length */
obuf = buf;
@@ -212,13 +210,13 @@ serial_m3110_con_setup(struct console *co, char *options)
int parity = 'n';
int flow = 'n';
- pr_info(PR_FMT "setting up console\n");
+ pr_info("setting up console\n");
if (co->index == -1)
co->index = 0;
if (!max) {
- pr_err(PR_FMT "pmax is NULL, return");
+ pr_err("pmax is NULL, return\n");
return -ENODEV;
}
@@ -296,8 +294,7 @@ static void send_circ_buf(struct uart_max3110 *max,
ret = max3110_write_then_read(max, obuf, ibuf, blen, 0);
if (ret)
- pr_warning(PR_FMT "%s(): get err msg %d\n",
- __func__, ret);
+ pr_warn("%s: get err msg %d\n", __func__, ret);
receive_chars(max, ibuf, len);
@@ -411,7 +408,7 @@ static int max3110_main_thread(void *_max)
int ret = 0;
struct circ_buf *xmit = &max->con_xmit;
- pr_info(PR_FMT "start main thread\n");
+ pr_info("start main thread\n");
do {
wait_event_interruptible(*wq,
@@ -455,7 +452,7 @@ static int max3110_read_thread(void *_max)
{
struct uart_max3110 *max = _max;
- pr_info(PR_FMT "start read thread\n");
+ pr_info("start read thread\n");
do {
/*
* If can't acquire the mutex, it means the main thread
@@ -481,7 +478,7 @@ static int serial_m3110_startup(struct uart_port *port)
int ret = 0;
if (port->line != 0) {
- pr_err(PR_FMT "uart port startup failed\n");
+ pr_err("uart port startup failed\n");
return -1;
}
@@ -504,7 +501,7 @@ static int serial_m3110_startup(struct uart_port *port)
if (IS_ERR(max->read_thread)) {
ret = PTR_ERR(max->read_thread);
max->read_thread = NULL;
- pr_err(PR_FMT "Can't create read thread!\n");
+ pr_err("Can't create read thread!\n");
return ret;
}
}
diff --git a/drivers/tty/vt/keyboard.c b/drivers/tty/vt/keyboard.c
index 9d00088..acfb4c0 100644
--- a/drivers/tty/vt/keyboard.c
+++ b/drivers/tty/vt/keyboard.c
@@ -926,7 +926,7 @@ static void k_brl(struct vc_data *vc, unsigned char value, char up_flag)
if (kbd->kbdmode != VC_UNICODE) {
if (!up_flag)
- pr_warning("keyboard mode must be unicode for braille patterns\n");
+ pr_warn("keyboard mode must be unicode for braille patterns\n");
return;
}
@@ -1310,8 +1310,8 @@ static void kbd_keycode(unsigned int keycode, int down, int hw_raw)
if (raw_mode && !hw_raw)
if (emulate_raw(vc, keycode, !down << 7))
if (keycode < BTN_MISC && printk_ratelimit())
- pr_warning("can't emulate rawmode for keycode %d\n",
- keycode);
+ pr_warn("can't emulate rawmode for keycode %d\n",
+ keycode);
#ifdef CONFIG_SPARC
if (keycode == KEY_A && sparc_l1_a_state) {
diff --git a/drivers/tty/vt/vt.c b/drivers/tty/vt/vt.c
index b33b00b..7b1665d 100644
--- a/drivers/tty/vt/vt.c
+++ b/drivers/tty/vt/vt.c
@@ -3849,8 +3849,8 @@ void do_unblank_screen(int leaving_gfx)
return;
if (!vc_cons_allocated(fg_console)) {
/* impossible */
- pr_warning("unblank_screen: tty %d not allocated ??\n",
- fg_console+1);
+ pr_warn("unblank_screen: tty %d not allocated ??\n",
+ fg_console + 1);
return;
}
vc = vc_cons[fg_console].d;
More information about the Linuxppc-dev
mailing list