Question about EHCI on P4080

Ruchika ruchika.k at servergy.com
Thu Feb 20 16:55:35 EST 2014


Hi,
I've been trying to understand why the uboot code is unable to work with 
USB1.1 devices.
On a USB analyzer:
I notice on an analyzer that there are no SOF or IN tokens seen on the 
bus at all. The only  after the very first setup packet is sent and ACK'd.

The board has a hub chip on it connected to the USB controller via a 
Ulpi interface.

Uboot debug indicates that the transfer times out and was still "Active"

The kernel code indicates that a companion driver handles 1.1 devices. 
Does this mean there are 2 HCD's, one for HS and one for FS/LS in the 
kernel ?
Thank you


ruchika


More information about the Linuxppc-dev mailing list