[PATCH 5/6 v5] kvm: booke: clear host tlb reference flag on guest tlb invalidation

[Scott Wood]

On Thu, 2013-09-19 at 11:32 +0530, Bharat Bhushan wrote:
> On booke, "struct tlbe_ref" contains host tlb mapping information
> (pfn: for guest-pfn to pfn, flags: attribute associated with this mapping)
> for a guest tlb entry. So when a guest creates a TLB entry then
> "struct tlbe_ref" is set to point to valid "pfn" and set attributes in
> "flags" field of the above said structure. When a guest TLB entry is
> invalidated then flags field of corresponding "struct tlbe_ref" is
> updated to point that this is no more valid, also we selectively clear
> some other attribute bits, example: if E500_TLB_BITMAP was set then we clear
> E500_TLB_BITMAP, if E500_TLB_TLB0 is set then we clear this.
> 
> Ideally we should clear complete "flags" as this entry is invalid and does not
> have anything to re-used. The other part of the problem is that when we use
> the same entry again then also we do not clear (started doing or-ing etc).
> 
> So far it was working because the selectively clearing mentioned above
> actually clears "flags" what was set during TLB mapping. But the problem
> starts coming when we add more attributes to this then we need to selectively
> clear them and which is not needed.
> 
> This patch we do both
>         - Clear "flags" when invalidating;
>         - Clear "flags" when reusing same entry later
> 
> Signed-off-by: Bharat Bhushan <bharat.bhushan at freescale.com>
> ---
> v3-> v5
>  - New patch (found this issue when doing vfio-pci development)
> 
>  arch/powerpc/kvm/e500_mmu_host.c |   12 +++++++-----
>  1 files changed, 7 insertions(+), 5 deletions(-)
> 
> diff --git a/arch/powerpc/kvm/e500_mmu_host.c b/arch/powerpc/kvm/e500_mmu_host.c
> index 1c6a9d7..60f5a3c 100644
> --- a/arch/powerpc/kvm/e500_mmu_host.c
> +++ b/arch/powerpc/kvm/e500_mmu_host.c
> @@ -217,7 +217,8 @@ void inval_gtlbe_on_host(struct kvmppc_vcpu_e500 *vcpu_e500, int tlbsel,
>  		}
>  		mb();
>  		vcpu_e500->g2h_tlb1_map[esel] = 0;
> -		ref->flags &= ~(E500_TLB_BITMAP | E500_TLB_VALID);
> +		/* Clear flags as TLB is not backed by the host anymore */
> +		ref->flags = 0;
>  		local_irq_restore(flags);
>  	}

This breaks when you have both E500_TLB_BITMAP and E500_TLB_TLB0 set.

Instead, just convert the final E500_TLB_VALID clearing at the end into
ref->flags = 0, and convert the early return a few lines earlier into
conditional execution of the tlbil_one().

-Scott