[PATCH] fsl/ehci: fix failure of checking PHY_CLK_VALID during reinitialization
Shengzhou Liu
Shengzhou.Liu at freescale.com
Mon Sep 2 15:25:52 EST 2013
In case of usb phy reinitialization:
e.g. insmod usb-module(usb works well) -> rmmod usb-module -> insmod usb-module
It found the PHY_CLK_VALID bit didn't work if it's not with the power-on reset.
So we just check PHY_CLK_VALID bit during the stage with POR, this can be met
by the tricky of checking FSL_SOC_USB_PRICTRL register.
Signed-off-by: Shengzhou Liu <Shengzhou.Liu at freescale.com>
---
based on master branch of upstream, from sdk1.4
drivers/usb/host/ehci-fsl.c | 5 +++--
1 files changed, 3 insertions(+), 2 deletions(-)
diff --git a/drivers/usb/host/ehci-fsl.c b/drivers/usb/host/ehci-fsl.c
index bd831ec..3156e12 100644
--- a/drivers/usb/host/ehci-fsl.c
+++ b/drivers/usb/host/ehci-fsl.c
@@ -270,8 +270,9 @@ static int ehci_fsl_setup_phy(struct usb_hcd *hcd,
if (pdata->have_sysif_regs && pdata->controller_ver &&
(phy_mode == FSL_USB2_PHY_ULPI)) {
/* check PHY_CLK_VALID to get phy clk valid */
- if (!spin_event_timeout(in_be32(non_ehci + FSL_SOC_USB_CTRL) &
- PHY_CLK_VALID, FSL_USB_PHY_CLK_TIMEOUT, 0)) {
+ if (!(spin_event_timeout(in_be32(non_ehci + FSL_SOC_USB_CTRL) &
+ PHY_CLK_VALID, FSL_USB_PHY_CLK_TIMEOUT, 0) ||
+ in_be32(non_ehci + FSL_SOC_USB_PRICTRL))) {
printk(KERN_WARNING "fsl-ehci: USB PHY clock invalid\n");
return -EINVAL;
}
--
1.7.0.4
More information about the Linuxppc-dev
mailing list