[PATCH] powerpc, perf: Configure BHRB filter before enabling PMU interrupts

[Anshuman Khandual]

On 10/09/2013 11:33 AM, Michael Ellerman wrote:
> On Wed, Oct 09, 2013 at 10:16:32AM +0530, Anshuman Khandual wrote:
>> On 10/09/2013 06:51 AM, Michael Ellerman wrote:
>>> On Tue, Oct 08, 2013 at 12:51:18PM +0530, Anshuman Khandual wrote:
>>>> On 10/08/2013 09:51 AM, Michael Ellerman wrote:
>>>>> On Mon, Oct 07, 2013 at 10:00:26AM +0530, Anshuman Khandual wrote:
>>>>>> Right now the `config_bhrb` PMU specific call happens after write_mmcr0
>>>>>> which actually enables the PMU for event counting and interrupt. So
>>>>>> there is a small window of time where the PMU and BHRB runs without the
>>>>>> required HW branch filter (if any) enabled in BHRB. This can cause some
>>>>>> of the branch samples to be collected through BHRB without any filter
>>>>>> being applied and hence affecting the correctness of the results. This
>>>>>> patch moves the BHRB config function call before enabling the interrupts.
>>>>>
>>>>> Patch looks good.
>>>>>
>>>>> But it reminds me I have an item in my TODO list:
>>>>>  - "Why can't config_bhrb() be done in compute_mmcr()" ?
>>>>>
>>>>
>>>> compute_mmcr() function deals with generic MMCR* configs for normal PMU
>>>> events. Even if BHRB config touches MMCRA register, it's configuration
>>>> does not interfere with the PMU config for general events. So its best
>>>> to keep them separate. 
>>>
>>> I'm unconvinced. If they'd been together to begin with this bug never
>>> would have happened.
>>
>> This is an ordering of configuration problem. Putting them together in the
>> same function does not rule out the chances of this ordering problem. Could
>> you please kindly explain how this could have been avoided ?
> 
> The existing code already makes sure to write MMCRA before MMCR0.
> 

Thats not true. One example being here at power_pmu_enable function.

        write_mmcr0(cpuhw, mmcr0);

        /*
         * Enable instruction sampling if necessary
         */
        if (cpuhw->mmcr[2] & MMCRA_SAMPLE_ENABLE) {
                mb();
                mtspr(SPRN_MMCRA, cpuhw->mmcr[2]);
        }

Even I think this is not right. Instruction sampling should have been
enabled before we enable PMU interrupts. Else there is a small window
of time where we could have the PMU enabled with events (which requires
sampling) without the sampling itself being enabled in MMCRA.

The only dependency BHRB and generic events have with each other is that
they both are ready for action once the PMU interrupt has been enabled
with MMCR0_PMXE bit.

Regards
Anshuman