[PATCH 2/2] ASoC: fsl_ssi: Add monaural audio support for non-ac97 interface

[Nicolin Chen]

On Fri, Nov 15, 2013 at 12:21:08PM +0000, Russell King - ARM Linux wrote:
> > @@ -517,10 +517,12 @@ static int fsl_ssi_hw_params(struct snd_pcm_substream *substream,
> >  {
> >  	struct fsl_ssi_private *ssi_private = snd_soc_dai_get_drvdata(cpu_dai);
> >  	struct ccsr_ssi __iomem *ssi = ssi_private->ssi;
> > +	unsigned int channels = params_channels(hw_params);
> >  	unsigned int sample_size =
> >  		snd_pcm_format_width(params_format(hw_params));
> >  	u32 wl = CCSR_SSI_SxCCR_WL(sample_size);
> >  	int enabled = read_ssi(&ssi->scr) & CCSR_SSI_SCR_SSIEN;
> > +	static u8 i2s_mode;
> 
> Throwing a static variable into the middle of a driver with none is a
> really horrid thing to do and is very bad programming practice.  What
> if some freescale device decides to have to of these interfaces?  Both
> will try to use this same static variable.
> 
> This is extremely bad programming practice.

Sir, I'm glad you're teaching me this lesson. I did hesitate before I
sent this patch, just couldn't tell the reason. And swear to god, I
hadn't used and will never use this practice again.
 

> > +	/* Save i2s mode configuration so that we can restore it later */
> > +	switch (read_ssi(&ssi->scr) & CCSR_SSI_SCR_I2S_MODE_MASK) {
> > +	case CCSR_SSI_SCR_I2S_MODE_SLAVE:
> > +	case CCSR_SSI_SCR_I2S_MODE_MASTER:
> > +		i2s_mode = read_ssi(&ssi->scr) & CCSR_SSI_SCR_I2S_MODE_MASK;
> > +	default:
> > +		break;
> > +	}
> 
> So all you're doing is saving the mode only if it specifies master or
> slave mode, but not if it's normal mode (== 0).  This just looks like
> it's complicated just for the sake of being complicated.
> 
> Since we know what mode this is in when we run fsl_ssi_setup(), can we
> not save that value into the fsl_ssi_private structure and re-use it
> here?

Currently we only have fsl_ssi_setup() to set I2S mode. It's definitely
a good idea to save it into private structure at that point. But there
will be new ASoC function -- set_dai_fmt() appending to this driver.
It will provide ASoC machine driver an interface to set I2S mode again,
and we must put a saving code as well at that time. So I think put the
saving code here would keep the modification within a small range. But
I here might be so obsessed with trying to make the patch as neat as
possible that I picked a demon sword.

But I'm still willing to learn the lesson. And I'll refine this patch.

Much obliged,
Nicolin Chen