SATA FSL and upstreaming

[Zang Roy-R61911]

> -----Original Message-----
> From: Linuxppc-dev [mailto:linuxppc-dev-bounces+tie-
> fei.zang=freescale.com at lists.ozlabs.org] On Behalf Of Bhushan Bharat-
> R65777
> Sent: Thursday, May 16, 2013 2:02 PM
> To: Benjamin Herrenschmidt; Liu Qiang-B32616
> Cc: Fleming Andy-AFLEMING; linuxppc-dev at lists.ozlabs.org; Xie Shaohui-
> B21989
> Subject: RE: SATA FSL and upstreaming
> 
> 
> 
> > -----Original Message-----
> > From: Linuxppc-dev [mailto:linuxppc-dev-
> > bounces+bharat.bhushan=freescale.com at lists.ozlabs.org] On Behalf Of
> > bounces+Benjamin
> > Herrenschmidt
> > Sent: Thursday, May 16, 2013 11:16 AM
> > To: Liu Qiang-B32616
> > Cc: linuxppc-dev at lists.ozlabs.org; Fleming Andy-AFLEMING; Xie
> > Shaohui-B21989
> > Subject: Re: SATA FSL and upstreaming
> >
> > On Thu, 2013-05-16 at 14:47 +1000, Benjamin Herrenschmidt wrote:
> > > Hi folks !
> > >
> > > So I was trying to use my 5020ds to test some stuff today. Since I
> > > hadn't used it in a while, I decided to "upgrade" it to the latest
> > > NOR etc...
> >
> > On another note, I can't seem to get any PCIe card recognized in any
> slot...
> >
> > Can you give me an example config of the DIP switches that is known to
> > work with some slots ? Is there some EEPROM config needed ? If yes,
> > any pointers ? (I can't quite make sense of either u-boot or the doc
> there).
> 
> Can you give RCW dump?
> Or can try the attached RCW.
I do not suggest changing the RCW. If the RCW is broken on Ben's side, it is not easy to recover for him.
Let's check the U-boot output first.
Thanks.
Roy