[PATCH] mmc: sdhci-pltfm: Fix timeout on t4240's sdhci controller

[Chunhe Lan]

On 03/08/2013 12:30 AM, Gala Kumar-B11780 wrote:
> On Mar 7, 2013, at 2:05 AM, Chunhe Lan wrote:
>
>> This patch fixes timeout problems on t4240's sdhci controller:
>>
>> 	mmc0: Too large timeout requested for CMD25!
>> 	mmc0: Too large timeout requested for CMD25!
>> 	mmc0: Too large timeout requested for CMD25!
>>
>> Signed-off-by: Chunhe Lan <Chunhe.Lan at freescale.com>
>> ---
>> drivers/mmc/host/sdhci-pltfm.c |    1 +
>> 1 files changed, 1 insertions(+), 0 deletions(-)
>>
>> diff --git a/drivers/mmc/host/sdhci-pltfm.c b/drivers/mmc/host/sdhci-pltfm.c
>> index 3145a78..9db7b12 100644
>> --- a/drivers/mmc/host/sdhci-pltfm.c
>> +++ b/drivers/mmc/host/sdhci-pltfm.c
>> @@ -94,6 +94,7 @@ void sdhci_get_of_property(struct platform_device *pdev)
>>
>> 		if (of_device_is_compatible(np, "fsl,p2020-esdhc") ||
>> 		    of_device_is_compatible(np, "fsl,p1010-esdhc") ||
>> +		    of_device_is_compatible(np, "fsl,t4240-esdhc") ||
>> 		    of_device_is_compatible(np, "fsl,mpc8536-esdhc"))
>> 			host->quirks |= SDHCI_QUIRK_BROKEN_TIMEOUT_VAL;
>>
>> -- 
>> 1.7.6.5
>>
>
> Why does this occur?  Is it a board issue?  Is it a silicon issue?  Is it due to some erratum?  Why T4 only?
      It would be the property of T4 hardware, and please see below the 
patch which locates
      the mail list of freescale:

eSDHC: mmc:host host need long time to generate command complete interrupt

According to Spec 2.0, command complete interrupt will generate within 
150 SD-CLK.
But this was not enough on T4240 board. So give it sufficient time to 
detect command
timeout. 1000 * HZ will be enough, this value was test on all T4 board, 
all worked well.

Signed-off-by: Jerry Huang <Chang-Ming.Huang at freescale.com>
Signed-off-by: Haijun Zhang <Haijun.Zhang at freescale.com>

Thanks,
Chunhe
>
> - k