[PATCH 5/5] mv643xx_eth: convert to use the Marvell Orion MDIO driver

Jason Gunthorpe jgunthorpe at obsidianresearch.com
Wed Jan 30 05:13:06 EST 2013


On Tue, Jan 29, 2013 at 04:24:08PM +0100, Florian Fainelli wrote:
> This patch converts the Marvell MV643XX ethernet driver to use the
> Marvell Orion MDIO driver. As a result, PowerPC and ARM platforms
> registering the Marvell MV643XX ethernet driver are also updated to
> register a Marvell Orion MDIO driver. This driver voluntarily overlaps
> with the Marvell Ethernet shared registers because it will use a subset
> of this shared register (shared_base + 0x4 - shared_base + 0x84). The
> Ethernet driver is also updated to look up for a PHY device using the
> Orion MDIO bus driver.

Can you finish off this job by making the mv643xx_eth driver accept
the standard phy-handle OF property instead of using a phy address?

Ie the end result should be something like:

                smi0: mdio at 72000 {
                        device_type = "mdio";
                        compatible = "marvell,orion-mdio";
                        reg = <0x72004 0x4>;

                        #address-cells = <1>;
                        #size-cells = <0>;
                        PHY1: ethernet-phy at 1 {
                                reg = <1>;
                                device_type = "ethernet-phy";
                                phy-id = <0x01410e90>;
                        };
                };

                egiga0 {
                        device_type = "network";
                        compatible = "marvell,mv643xx-eth";
                        reg = <0x72000 0x4000>;
                        port_number = <0>;
                        phy-handle = <&PHY1>;
                        interrupts = <11>;
                        local-mac-address = [000000000002];  /* Filled by boot loader */
                };

Regards,
Jason


More information about the Linuxppc-dev mailing list