[PATCH] Added device tree binding for TDM and TDM phy

Scott Wood scottwood at freescale.com
Thu Jan 10 11:07:05 EST 2013


On 01/09/2013 01:10:24 AM, Singh Sandeep-B37400 wrote:
> A gentle reminder.
> Any comments are appreciated.
> 
> Regards,
> Sandeep
> 
> > -----Original Message-----
> > From: Singh Sandeep-B37400
> > Sent: Wednesday, January 02, 2013 6:55 PM
> > To: devicetree-discuss at lists.ozlabs.org; linuxppc-dev at ozlabs.org
> > Cc: Singh Sandeep-B37400; Aggrwal Poonam-B10812
> > Subject: [PATCH] Added device tree binding for TDM and TDM phy
> >
> > This controller is available on many Freescale SOCs like MPC8315,  
> P1020,
> > P1010 and P1022
> >
> > Signed-off-by: Sandeep Singh <Sandeep at freescale.com>
> > Signed-off-by: Poonam Aggrwal <poonam.aggrwal at freescale.com>
> > ---
> >  .../devicetree/bindings/powerpc/fsl/fsl-tdm.txt    |   63
> > ++++++++++++++++++++
> >  .../devicetree/bindings/powerpc/fsl/tdm-phy.txt    |   38  
> ++++++++++++
> >  2 files changed, 101 insertions(+), 0 deletions(-)  create mode  
> 100644
> > Documentation/devicetree/bindings/powerpc/fsl/fsl-tdm.txt
> >  create mode 100644  
> Documentation/devicetree/bindings/powerpc/fsl/tdm-
> > phy.txt
> >
> > diff --git  
> a/Documentation/devicetree/bindings/powerpc/fsl/fsl-tdm.txt
> > b/Documentation/devicetree/bindings/powerpc/fsl/fsl-tdm.txt
> > new file mode 100644
> > index 0000000..ceb2ef1
> > --- /dev/null
> > +++ b/Documentation/devicetree/bindings/powerpc/fsl/fsl-tdm.txt
> > @@ -0,0 +1,63 @@
> > +TDM Device Tree Binding
> > +
> > +NOTE: The bindings described in this document are preliminary and
> > +subject to change.
> > +
> > +TDM (Time Division Multiplexing)
> > +
> > +Description:
> > +
> > +The TDM is full duplex serial port designed to allow various  
> devices
> > +including digital signal processors (DSPs) to communicate with a
> > +variety of serial devices including industry standard framers,  
> codecs,
> > other DSPs and microprocessors.
> > +
> > +The below properties describe the device tree bindings for  
> Freescale
> > +TDM controller. This TDM controller is available on various  
> Freescale
> > +Processors like MPC8315, P1020, P1022 and P1010.
> > +
> > +Required properties:
> > +
> > +- compatible
> > +    Value type: <string>
> > +    Definition: Should contain "fsl,tdm1.0".
> > +
> > +- reg
> > +    Definition: A standard property. The first reg specifier  
> describes
> > the TDM
> > +    registers, and the second describes the TDM DMAC registers.
> > +
> > +- tdm_tx_clk
> > +    Value type: <u32 or u64>
> > +    Definition: This specifies the value of transmit clock. It  
> should
> > not
> > +    exceed 50Mhz.
> > +
> > +- tdm_rx_clk
> > +    Value type: <u32 or u64>
> > +    Definition: This specifies the value of receive clock. Its  
> value
> > could be
> > +    zero, in which case tdm will operate in shared mode. Its value
> > should not
> > +    exceed 50Mhz.

Please don't use underscores in property names, and use the vendor  
prefix: "fsl,tdm-tx-clk" and "fsl,tdm-rx-clk".

> > diff --git  
> a/Documentation/devicetree/bindings/powerpc/fsl/tdm-phy.txt
> > b/Documentation/devicetree/bindings/powerpc/fsl/tdm-phy.txt
> > new file mode 100644
> > index 0000000..2563934
> > --- /dev/null
> > +++ b/Documentation/devicetree/bindings/powerpc/fsl/tdm-phy.txt
> > @@ -0,0 +1,38 @@
> > +TDM PHY Device Tree Binding
> > +
> > +NOTE: The bindings described in this document are preliminary and
> > +subject to change.
> > +
> > +Description:
> > +TDM PHY is the terminal interface of TDM subsystem. It is  
> typically a
> > +line control device like E1/T1 framer or SLIC. A TDM device can  
> have
> > +multiple TDM PHYs.
> > +
> > +Required properties:
> > +
> > +- compatible
> > +    Value type: <string>
> > +    Definition: Should contain generic compatibility like  
> "tdm-phy-slic"
> > or
> > +    "tdm-phy-e1" or "tdm-phy-t1".

Does this "generic" string (plus the other properties) tell you all you  
need to know about the device?  If there are other possible "generic"  
compatibles, they should be listed or else different people will make  
up different strings for the same thing.

-Scott


More information about the Linuxppc-dev mailing list