[PATCH v5 04/45] percpu_rwlock: Implement the core design of Per-CPU Reader-Writer Locks

Paul E. McKenney paulmck at linux.vnet.ibm.com
Sat Feb 9 10:10:17 EST 2013


On Tue, Jan 22, 2013 at 01:03:53PM +0530, Srivatsa S. Bhat wrote:
> Using global rwlocks as the backend for per-CPU rwlocks helps us avoid many
> lock-ordering related problems (unlike per-cpu locks). However, global
> rwlocks lead to unnecessary cache-line bouncing even when there are no
> writers present, which can slow down the system needlessly.
> 
> Per-cpu counters can help solve the cache-line bouncing problem. So we
> actually use the best of both: per-cpu counters (no-waiting) at the reader
> side in the fast-path, and global rwlocks in the slowpath.
> 
> [ Fastpath = no writer is active; Slowpath = a writer is active ]
> 
> IOW, the readers just increment/decrement their per-cpu refcounts (disabling
> interrupts during the updates, if necessary) when no writer is active.
> When a writer becomes active, he signals all readers to switch to global
> rwlocks for the duration of his activity. The readers switch over when it
> is safe for them (ie., when they are about to start a fresh, non-nested
> read-side critical section) and start using (holding) the global rwlock for
> read in their subsequent critical sections.
> 
> The writer waits for every existing reader to switch, and then acquires the
> global rwlock for write and enters his critical section. Later, the writer
> signals all readers that he is done, and that they can go back to using their
> per-cpu refcounts again.
> 
> Note that the lock-safety (despite the per-cpu scheme) comes from the fact
> that the readers can *choose* _when_ to switch to rwlocks upon the writer's
> signal. And the readers don't wait on anybody based on the per-cpu counters.
> The only true synchronization that involves waiting at the reader-side in this
> scheme, is the one arising from the global rwlock, which is safe from circular
> locking dependency issues.
> 
> Reader-writer locks and per-cpu counters are recursive, so they can be
> used in a nested fashion in the reader-path, which makes per-CPU rwlocks also
> recursive. Also, this design of switching the synchronization scheme ensures
> that you can safely nest and use these locks in a very flexible manner.
> 
> I'm indebted to Michael Wang and Xiao Guangrong for their numerous thoughtful
> suggestions and ideas, which inspired and influenced many of the decisions in
> this as well as previous designs. Thanks a lot Michael and Xiao!

Looks pretty close!  Some comments interspersed below.  Please either
fix the code or my confusion, as the case may be.  ;-)

							Thanx, Paul

> Cc: David Howells <dhowells at redhat.com>
> Signed-off-by: Srivatsa S. Bhat <srivatsa.bhat at linux.vnet.ibm.com>
> ---
> 
>  include/linux/percpu-rwlock.h |   10 +++
>  lib/percpu-rwlock.c           |  128 ++++++++++++++++++++++++++++++++++++++++-
>  2 files changed, 136 insertions(+), 2 deletions(-)
> 
> diff --git a/include/linux/percpu-rwlock.h b/include/linux/percpu-rwlock.h
> index 8dec8fe..6819bb8 100644
> --- a/include/linux/percpu-rwlock.h
> +++ b/include/linux/percpu-rwlock.h
> @@ -68,4 +68,14 @@ extern void percpu_free_rwlock(struct percpu_rwlock *);
>  	__percpu_init_rwlock(pcpu_rwlock, #pcpu_rwlock, &rwlock_key);	\
>  })
> 
> +#define reader_uses_percpu_refcnt(pcpu_rwlock, cpu)			\
> +		(ACCESS_ONCE(per_cpu(*((pcpu_rwlock)->reader_refcnt), cpu)))
> +
> +#define reader_nested_percpu(pcpu_rwlock)				\
> +			(__this_cpu_read(*((pcpu_rwlock)->reader_refcnt)) > 1)
> +
> +#define writer_active(pcpu_rwlock)					\
> +			(__this_cpu_read(*((pcpu_rwlock)->writer_signal)))
> +
>  #endif
> +
> diff --git a/lib/percpu-rwlock.c b/lib/percpu-rwlock.c
> index 80dad93..992da5c 100644
> --- a/lib/percpu-rwlock.c
> +++ b/lib/percpu-rwlock.c
> @@ -64,21 +64,145 @@ void percpu_free_rwlock(struct percpu_rwlock *pcpu_rwlock)
> 
>  void percpu_read_lock(struct percpu_rwlock *pcpu_rwlock)
>  {
> -	read_lock(&pcpu_rwlock->global_rwlock);
> +	preempt_disable();
> +
> +	/* First and foremost, let the writer know that a reader is active */
> +	this_cpu_inc(*pcpu_rwlock->reader_refcnt);
> +
> +	/*
> +	 * If we are already using per-cpu refcounts, it is not safe to switch
> +	 * the synchronization scheme. So continue using the refcounts.
> +	 */
> +	if (reader_nested_percpu(pcpu_rwlock)) {
> +		goto out;
> +	} else {
> +		/*
> +		 * The write to 'reader_refcnt' must be visible before we
> +		 * read 'writer_signal'.
> +		 */
> +		smp_mb(); /* Paired with smp_rmb() in sync_reader() */
> +
> +		if (likely(!writer_active(pcpu_rwlock))) {
> +			goto out;
> +		} else {
> +			/* Writer is active, so switch to global rwlock. */
> +			read_lock(&pcpu_rwlock->global_rwlock);
> +
> +			/*
> +			 * We might have raced with a writer going inactive
> +			 * before we took the read-lock. So re-evaluate whether
> +			 * we still need to hold the rwlock or if we can switch
> +			 * back to per-cpu refcounts. (This also helps avoid
> +			 * heterogeneous nesting of readers).
> +			 */
> +			if (writer_active(pcpu_rwlock))

The above writer_active() can be reordered with the following this_cpu_dec(),
strange though it might seem.  But this is OK because holding the rwlock
is conservative.  But might be worth a comment.

> +				this_cpu_dec(*pcpu_rwlock->reader_refcnt);
> +			else

In contrast, no reordering can happen here because read_unlock() is
required to keep the critical section underneath the lock.

> +				read_unlock(&pcpu_rwlock->global_rwlock);
> +		}
> +	}
> +
> +out:
> +	/* Prevent reordering of any subsequent reads */
> +	smp_rmb();

This should be smp_mb().  "Readers" really can do writes.  Hence the
name lglock -- "local/global" rather than "reader/writer".

>  }
> 
>  void percpu_read_unlock(struct percpu_rwlock *pcpu_rwlock)
>  {
> -	read_unlock(&pcpu_rwlock->global_rwlock);

We need an smp_mb() here to keep the critical section ordered before the
this_cpu_dec() below.  Otherwise, if a writer shows up just after we
exit the fastpath, that writer is not guaranteed to see the effects of
our critical section.  Equivalently, the prior read-side critical section
just might see some of the writer's updates, which could be a bit of
a surprise to the reader.

> +	/*
> +	 * We never allow heterogeneous nesting of readers. So it is trivial
> +	 * to find out the kind of reader we are, and undo the operation
> +	 * done by our corresponding percpu_read_lock().
> +	 */
> +	if (__this_cpu_read(*pcpu_rwlock->reader_refcnt)) {
> +		this_cpu_dec(*pcpu_rwlock->reader_refcnt);
> +		smp_wmb(); /* Paired with smp_rmb() in sync_reader() */

Given an smp_mb() above, I don't understand the need for this smp_wmb().
Isn't the idea that if the writer sees ->reader_refcnt decremented to
zero, it also needs to see the effects of the corresponding reader's
critical section?

Or am I missing something subtle here?  In any case, if this smp_wmb()
really is needed, there should be some subsequent write that the writer
might observe.  From what I can see, there is no subsequent write from
this reader that the writer cares about.

> +	} else {
> +		read_unlock(&pcpu_rwlock->global_rwlock);
> +	}
> +
> +	preempt_enable();
> +}
> +
> +static inline void raise_writer_signal(struct percpu_rwlock *pcpu_rwlock,
> +				       unsigned int cpu)
> +{
> +	per_cpu(*pcpu_rwlock->writer_signal, cpu) = true;
> +}
> +
> +static inline void drop_writer_signal(struct percpu_rwlock *pcpu_rwlock,
> +				      unsigned int cpu)
> +{
> +	per_cpu(*pcpu_rwlock->writer_signal, cpu) = false;
> +}
> +
> +static void announce_writer_active(struct percpu_rwlock *pcpu_rwlock)
> +{
> +	unsigned int cpu;
> +
> +	for_each_online_cpu(cpu)
> +		raise_writer_signal(pcpu_rwlock, cpu);
> +
> +	smp_mb(); /* Paired with smp_rmb() in percpu_read_[un]lock() */
> +}
> +
> +static void announce_writer_inactive(struct percpu_rwlock *pcpu_rwlock)
> +{
> +	unsigned int cpu;
> +
> +	drop_writer_signal(pcpu_rwlock, smp_processor_id());

Why do we drop ourselves twice?  More to the point, why is it important to
drop ourselves first?

> +
> +	for_each_online_cpu(cpu)
> +		drop_writer_signal(pcpu_rwlock, cpu);
> +
> +	smp_mb(); /* Paired with smp_rmb() in percpu_read_[un]lock() */
> +}
> +
> +/*
> + * Wait for the reader to see the writer's signal and switch from percpu
> + * refcounts to global rwlock.
> + *
> + * If the reader is still using percpu refcounts, wait for him to switch.
> + * Else, we can safely go ahead, because either the reader has already
> + * switched over, or the next reader that comes along on that CPU will
> + * notice the writer's signal and will switch over to the rwlock.
> + */
> +static inline void sync_reader(struct percpu_rwlock *pcpu_rwlock,
> +			       unsigned int cpu)
> +{
> +	smp_rmb(); /* Paired with smp_[w]mb() in percpu_read_[un]lock() */

As I understand it, the purpose of this memory barrier is to ensure
that the stores in drop_writer_signal() happen before the reads from
->reader_refcnt in reader_uses_percpu_refcnt(), thus preventing the
race between a new reader attempting to use the fastpath and this writer
acquiring the lock.  Unless I am confused, this must be smp_mb() rather
than smp_rmb().

Also, why not just have a single smp_mb() at the beginning of
sync_all_readers() instead of executing one barrier per CPU?

> +
> +	while (reader_uses_percpu_refcnt(pcpu_rwlock, cpu))
> +		cpu_relax();
> +}
> +
> +static void sync_all_readers(struct percpu_rwlock *pcpu_rwlock)
> +{
> +	unsigned int cpu;
> +
> +	for_each_online_cpu(cpu)
> +		sync_reader(pcpu_rwlock, cpu);
>  }
> 
>  void percpu_write_lock(struct percpu_rwlock *pcpu_rwlock)
>  {
> +	/*
> +	 * Tell all readers that a writer is becoming active, so that they
> +	 * start switching over to the global rwlock.
> +	 */
> +	announce_writer_active(pcpu_rwlock);
> +	sync_all_readers(pcpu_rwlock);
>  	write_lock(&pcpu_rwlock->global_rwlock);
>  }
> 
>  void percpu_write_unlock(struct percpu_rwlock *pcpu_rwlock)
>  {
> +	/*
> +	 * Inform all readers that we are done, so that they can switch back
> +	 * to their per-cpu refcounts. (We don't need to wait for them to
> +	 * see it).
> +	 */
> +	announce_writer_inactive(pcpu_rwlock);
>  	write_unlock(&pcpu_rwlock->global_rwlock);
>  }
> 
> 



More information about the Linuxppc-dev mailing list