[PATCH] mpic: fix Destination Registers init problem

[Scott Wood]

On 02/07/2013 02:07:00 AM, Zhao Chenhui wrote:
> The Freescale implementation of the MPIC only allows a single CPU
> destination for non-IPI interrupts. Test the flag MPIC_SINGLE_DEST_CPU
> to check if the Destination registers should be set.
> 
> This prevents more than one bit is set at secondary processors
> initilizing time if the flag MPIC_SINGLE_DEST_CPU is set.
> 
> Signed-off-by: Zhao Chenhui <chenhui.zhao at freescale.com>
> Signed-off-by: Li Yang <leoli at freescale.com>
> ---
>  arch/powerpc/sysdev/mpic.c |    2 +-
>  1 files changed, 1 insertions(+), 1 deletions(-)
> 
> diff --git a/arch/powerpc/sysdev/mpic.c b/arch/powerpc/sysdev/mpic.c
> index 9c6e535..cc537f8 100644
> --- a/arch/powerpc/sysdev/mpic.c
> +++ b/arch/powerpc/sysdev/mpic.c
> @@ -1675,7 +1675,7 @@ void mpic_setup_this_cpu(void)
>  	 * it differently, then we should make sure we also change the  
> default
>  	 * values of irq_desc[].affinity in irq.c.
>   	 */
> -	if (distribute_irqs) {
> +	if (distribute_irqs && !(mpic->flags & MPIC_SINGLE_DEST_CPU)) {
>  	 	for (i = 0; i < mpic->num_sources ; i++)
>  			mpic_irq_write(i, MPIC_INFO(IRQ_DESTINATION),
>  				mpic_irq_read(i,  
> MPIC_INFO(IRQ_DETINATION)) | msk);

http://patchwork.ozlabs.org/patch/211454/

-Scott