[PATCH 2/2] [POWERPC] uprobes: powerpc port

[Ananth N Mavinakayanahalli]

On Fri, Jun 08, 2012 at 03:51:54PM +1000, Michael Ellerman wrote:
> On Fri, 2012-06-08 at 10:06 +0530, Ananth N Mavinakayanahalli wrote:
> > On Wed, Jun 06, 2012 at 11:08:04AM -0700, Jim Keniston wrote:
> > > On Wed, 2012-06-06 at 15:05 +0530, Ananth N Mavinakayanahalli wrote:
> > > > On Wed, Jun 06, 2012 at 11:27:02AM +0200, Peter Zijlstra wrote:
> > > > > On Wed, 2012-06-06 at 14:51 +0530, Ananth N Mavinakayanahalli wrote:
> > 
> > ...
> > 
> > > > For the kernel, the only ones that are off limits are rfi (return from
> > > > interrupt), mtmsr (move to msr). All other instructions can be probed.
> > > > 
> > > > Both those instructions are supervisor level, so we won't see them in
> > > > userspace at all; so we should be able to probe all user level
> > > > instructions.
> > > 
> > > Presumably rfi or mtmsr could show up in the instruction stream via an
> > > erroneous or mischievous asm statement.  It'd be good to verify that you
> > > handle that gracefully.
> > 
> > That'd be flagged elsewhere, by the architecture itself -- you'd get a
> > privileged instruciton exception if you try execute any instruction not
> > part of the UISA. I therefore don't think its a necessary check in the
> > uprobes code.
> 
> But you're not executing the instruction, you're passing it to
> emulate_step(). Or am I missing something?

But MSR_PR=1 and hence emulate_step() will return -1 and hence we will
end up single-stepping using user_enable_single_step(). Same with rfid.

Ananth