[PATCH v3 5/8] [ppc] Define virtual-physical translations for RELOCATABLE
Suzuki K. Poulose
suzuki at in.ibm.com
Mon Nov 14 16:43:32 EST 2011
We find the runtime address of _stext and relocate ourselves based
on the following calculation.
virtual_base = ALIGN(KERNELBASE,KERNEL_TLB_PIN_SIZE) +
MODULO(_stext.run,KERNEL_TLB_PIN_SIZE)
relocate() is called with the Effective Virtual Base Address (as
shown below)
| Phys. Addr| Virt. Addr |
Page |------------------------|
Boundary | | |
| | |
| | |
Kernel Load |___________|_ __ _ _ _ _|<- Effective
Addr(_stext)| | ^ |Virt. Base Addr
| | | |
| | | |
| |reloc_offset|
| | | |
| | | |
| |______v_____|<-(KERNELBASE)%TLB_SIZE
| | |
| | |
| | |
Page |-----------|------------|
Boundary | | |
On BookE, we need __va() & __pa() early in the boot process to access
the device tree.
Currently this has been defined as :
#define __va(x) ((void *)(unsigned long)((phys_addr_t)(x) -
PHYSICAL_START + KERNELBASE)
where:
PHYSICAL_START is kernstart_addr - a variable updated at runtime.
KERNELBASE is the compile time Virtual base address of kernel.
This won't work for us, as kernstart_addr is dynamic and will yield different
results for __va()/__pa() for same mapping.
e.g.,
Let the kernel be loaded at 64MB and KERNELBASE be 0xc0000000 (same as
PAGE_OFFSET).
In this case, we would be mapping 0 to 0xc0000000, and kernstart_addr = 64M
Now __va(1MB) = (0x100000) - (0x4000000) + 0xc0000000
= 0xbc100000 , which is wrong.
it should be : 0xc0000000 + 0x100000 = 0xc0100000
On platforms which support AMP, like PPC_47x (based on 44x), the kernel
could be loaded at highmem. Hence we cannot always depend on the compile
time constants for mapping.
Here are the possible solutions:
1) Update kernstart_addr(PHSYICAL_START) to match the Physical address of
compile time KERNELBASE value, instead of the actual Physical_Address(_stext).
The disadvantage is that we may break other users of PHYSICAL_START. They
could be replaced with __pa(_stext).
2) Redefine __va() & __pa() with relocation offset
#ifdef CONFIG_RELOCATABLE_PPC32
#define __va(x) ((void *)(unsigned long)((phys_addr_t)(x) - PHYSICAL_START + (KERNELBASE + RELOC_OFFSET)))
#define __pa(x) ((unsigned long)(x) + PHYSICAL_START - (KERNELBASE + RELOC_OFFSET))
#endif
where, RELOC_OFFSET could be
a) A variable, say relocation_offset (like kernstart_addr), updated
at boot time. This impacts performance, as we have to load an additional
variable from memory.
OR
b) #define RELOC_OFFSET ((PHYSICAL_START & PPC_PIN_SIZE_OFFSET_MASK) - \
(KERNELBASE & PPC_PIN_SIZE_OFFSET_MASK))
This introduces more calculations for doing the translation.
3) Redefine __va() & __pa() with a new variable
i.e,
#define __va(x) ((void *)(unsigned long)((phys_addr_t)(x) + VIRT_PHYS_OFFSET))
where VIRT_PHYS_OFFSET :
#ifdef CONFIG_RELOCATABLE_PPC32
#define VIRT_PHYS_OFFSET virt_phys_offset
#else
#define VIRT_PHYS_OFFSET (KERNELBASE - PHYSICAL_START)
#endif /* CONFIG_RELOCATABLE_PPC32 */
where virt_phy_offset is updated at runtime to :
Effective KERNELBASE - kernstart_addr.
Taking our example, above:
virt_phys_offset = effective_kernelstart_vaddr - kernstart_addr
= 0xc0400000 - 0x400000
= 0xc0000000
and
__va(0x100000) = 0xc0000000 + 0x100000 = 0xc0100000
which is what we want.
I have implemented (3) in the following patch which has same cost of
operation as the existing one.
I have tested the patches on 440x platforms only. However this should
work fine for PPC_47x also, as we only depend on the runtime address
and the current TLB XLAT entry for the startup code, which is available
in r25. I don't have access to a 47x board yet. So, it would be great if
somebody could test this on 47x.
Signed-off-by: Suzuki K. Poulose <suzuki at in.ibm.com>
Cc: Benjamin Herrenschmidt <benh at kernel.crashing.org>
Cc: Kumar Gala <galak at kernel.crashing.org>
Cc: linuxppc-dev <linuxppc-dev at lists.ozlabs.org>
---
arch/powerpc/include/asm/page.h | 85 ++++++++++++++++++++++++++++++++++++++-
arch/powerpc/mm/init_32.c | 7 +++
2 files changed, 89 insertions(+), 3 deletions(-)
diff --git a/arch/powerpc/include/asm/page.h b/arch/powerpc/include/asm/page.h
index 97cfe86..a8d0888 100644
--- a/arch/powerpc/include/asm/page.h
+++ b/arch/powerpc/include/asm/page.h
@@ -97,12 +97,26 @@ extern unsigned int HPAGE_SHIFT;
extern phys_addr_t memstart_addr;
extern phys_addr_t kernstart_addr;
+
+#ifdef CONFIG_RELOCATABLE_PPC32
+extern long long virt_phys_offset;
#endif
+
+#endif /* __ASSEMBLY__ */
#define PHYSICAL_START kernstart_addr
-#else
+
+#else /* !CONFIG_RELOCATABLE */
#define PHYSICAL_START ASM_CONST(CONFIG_PHYSICAL_START)
#endif
+/* See Description below for VIRT_PHYS_OFFSET */
+#ifdef CONFIG_RELOCATABLE_PPC32
+#define VIRT_PHYS_OFFSET virt_phys_offset
+#else
+#define VIRT_PHYS_OFFSET (KERNELBASE - PHYSICAL_START)
+#endif
+
+
#ifdef CONFIG_PPC64
#define MEMORY_START 0UL
#elif defined(CONFIG_RELOCATABLE) || defined(CONFIG_DYNAMIC_MEMSTART)
@@ -125,12 +139,77 @@ extern phys_addr_t kernstart_addr;
* determine MEMORY_START until then. However we can determine PHYSICAL_START
* from information at hand (program counter, TLB lookup).
*
+ * On BookE with RELOCATABLE (RELOCATABLE_PPC32)
+ *
+ * With RELOCATABLE_PPC32, we support loading the kernel at any physical
+ * address without any restriction on the page alignment.
+ *
+ * We find the runtime address of _stext and relocate ourselves based on
+ * the following calculation:
+ *
+ * virtual_base = ALIGN_DOWN(KERNELBASE,256M) +
+ * MODULO(_stext.run,256M)
+ * and create the following mapping:
+ *
+ * ALIGN_DOWN(_stext.run,256M) => ALIGN_DOWN(KERNELBASE,256M)
+ *
+ * When we process relocations, we cannot depend on the
+ * existing equation for the __va()/__pa() translations:
+ *
+ * __va(x) = (x) - PHYSICAL_START + KERNELBASE
+ *
+ * Where:
+ * PHYSICAL_START = kernstart_addr = Physical address of _stext
+ * KERNELBASE = Compiled virtual address of _stext.
+ *
+ * This formula holds true iff, kernel load address is TLB page aligned.
+ *
+ * In our case, we need to also account for the shift in the kernel Virtual
+ * address.
+ *
+ * E.g.,
+ *
+ * Let the kernel be loaded at 64MB and KERNELBASE be 0xc0000000 (same as PAGE_OFFSET).
+ * In this case, we would be mapping 0 to 0xc0000000, and kernstart_addr = 64M
+ *
+ * Now __va(1MB) = (0x100000) - (0x4000000) + 0xc0000000
+ * = 0xbc100000 , which is wrong.
+ *
+ * Rather, it should be : 0xc0000000 + 0x100000 = 0xc0100000
+ * according to our mapping.
+ *
+ * Hence we use the following formula to get the translations right:
+ *
+ * __va(x) = (x) - [ PHYSICAL_START - Effective KERNELBASE ]
+ *
+ * Where :
+ * PHYSICAL_START = dynamic load address.(kernstart_addr variable)
+ * Effective KERNELBASE = virtual_base =
+ * = ALIGN_DOWN(KERNELBASE,256M) +
+ * MODULO(PHYSICAL_START,256M)
+ *
+ * To make the cost of __va() / __pa() more light weight, we introduce
+ * a new variable virt_phys_offset, which will hold :
+ *
+ * virt_phys_offset = Effective KERNELBASE - PHYSICAL_START
+ * = ALIGN_DOWN(KERNELBASE,256M) -
+ * ALIGN_DOWN(PHYSICALSTART,256M)
+ *
+ * Hence :
+ *
+ * __va(x) = x - PHYSICAL_START + Effective KERNELBASE
+ * = x + virt_phys_offset
+ *
+ * and
+ * __pa(x) = x + PHYSICAL_START - Effective KERNELBASE
+ * = x - virt_phys_offset
+ *
* On non-Book-E PPC64 PAGE_OFFSET and MEMORY_START are constants so use
* the other definitions for __va & __pa.
*/
#ifdef CONFIG_BOOKE
-#define __va(x) ((void *)(unsigned long)((phys_addr_t)(x) - PHYSICAL_START + KERNELBASE))
-#define __pa(x) ((unsigned long)(x) + PHYSICAL_START - KERNELBASE)
+#define __va(x) ((void *)(unsigned long)((phys_addr_t)(x) + VIRT_PHYS_OFFSET))
+#define __pa(x) ((unsigned long)(x) - VIRT_PHYS_OFFSET)
#else
#define __va(x) ((void *)(unsigned long)((phys_addr_t)(x) + PAGE_OFFSET - MEMORY_START))
#define __pa(x) ((unsigned long)(x) - PAGE_OFFSET + MEMORY_START)
diff --git a/arch/powerpc/mm/init_32.c b/arch/powerpc/mm/init_32.c
index 161cefd..60a4e4e 100644
--- a/arch/powerpc/mm/init_32.c
+++ b/arch/powerpc/mm/init_32.c
@@ -65,6 +65,13 @@ phys_addr_t memstart_addr = (phys_addr_t)~0ull;
EXPORT_SYMBOL(memstart_addr);
phys_addr_t kernstart_addr;
EXPORT_SYMBOL(kernstart_addr);
+
+#ifdef CONFIG_RELOCATABLE_PPC32
+/* Used in __va()/__pa() */
+long long virt_phys_offset;
+EXPORT_SYMBOL(virt_phys_offset);
+#endif
+
phys_addr_t lowmem_end_addr;
int boot_mapsize;
More information about the Linuxppc-dev
mailing list