[PATCH v2 3/7] mmc: sdhci: make sdhci-of device drivers self registered

Shawn Guo shawn.guo at freescale.com
Fri May 6 12:15:05 EST 2011


On Thu, May 05, 2011 at 06:23:44PM +0400, Anton Vorontsov wrote:
> On Thu, May 05, 2011 at 09:22:54PM +0800, Shawn Guo wrote:
> [...]
> > - * Copyright (c) 2007 Freescale Semiconductor, Inc.
> > - * Copyright (c) 2009 MontaVista Software, Inc.
> > - *
> > - * Authors: Xiaobo Xie <X.Xie at freescale.com>
> > - *	    Anton Vorontsov <avorontsov at ru.mvista.com>
> [...]
> > -#ifdef CONFIG_MMC_SDHCI_BIG_ENDIAN_32BIT_BYTE_SWAPPER
> > -
> > -/*
> > - * These accessors are designed for big endian hosts doing I/O to
> > - * little endian controllers incorporating a 32-bit hardware byte swapper.
> > - */
> > -
> > -u32 sdhci_be32bs_readl(struct sdhci_host *host, int reg)
> > -{
> > -	return in_be32(host->ioaddr + reg);
> > -}
> > -
> > -u16 sdhci_be32bs_readw(struct sdhci_host *host, int reg)
> > -{
> > -	return in_be16(host->ioaddr + (reg ^ 0x2));
> > -}
> > -
> > -u8 sdhci_be32bs_readb(struct sdhci_host *host, int reg)
> > -{
> > -	return in_8(host->ioaddr + (reg ^ 0x3));
> > -}
> > -
> > -void sdhci_be32bs_writel(struct sdhci_host *host, u32 val, int reg)
> > -{
> > -	out_be32(host->ioaddr + reg, val);
> > -}
> > -
> > -void sdhci_be32bs_writew(struct sdhci_host *host, u16 val, int reg)
> > -{
> > -	struct sdhci_pltfm_host *pltfm_host = sdhci_priv(host);
> > -	int base = reg & ~0x3;
> > -	int shift = (reg & 0x2) * 8;
> > -
> > -	switch (reg) {
> > -	case SDHCI_TRANSFER_MODE:
> > -		/*
> > -		 * Postpone this write, we must do it together with a
> > -		 * command write that is down below.
> > -		 */
> > -		pltfm_host->xfer_mode_shadow = val;
> > -		return;
> > -	case SDHCI_COMMAND:
> > -		sdhci_be32bs_writel(host, val << 16 | pltfm_host->xfer_mode_shadow,
> > -				    SDHCI_TRANSFER_MODE);
> > -		return;
> > -	}
> > -	clrsetbits_be32(host->ioaddr + base, 0xffff << shift, val << shift);
> > -}
> > -
> > -void sdhci_be32bs_writeb(struct sdhci_host *host, u8 val, int reg)
> > -{
> > -	int base = reg & ~0x3;
> > -	int shift = (reg & 0x3) * 8;
> > -
> > -	clrsetbits_be32(host->ioaddr + base , 0xff << shift, val << shift);
> > -}
> > -#endif /* CONFIG_MMC_SDHCI_BIG_ENDIAN_32BIT_BYTE_SWAPPER */
> [...]
> > +#ifdef CONFIG_MMC_SDHCI_BIG_ENDIAN_32BIT_BYTE_SWAPPER
> > +/*
> > + * These accessors are designed for big endian hosts doing I/O to
> > + * little endian controllers incorporating a 32-bit hardware byte swapper.
> > + */
> > +u32 sdhci_be32bs_readl(struct sdhci_host *host, int reg)
> > +{
> > +	return in_be32(host->ioaddr + reg);
> > +}
> > +
> > +u16 sdhci_be32bs_readw(struct sdhci_host *host, int reg)
> > +{
> > +	return in_be16(host->ioaddr + (reg ^ 0x2));
> > +}
> > +
> > +u8 sdhci_be32bs_readb(struct sdhci_host *host, int reg)
> > +{
> > +	return in_8(host->ioaddr + (reg ^ 0x3));
> > +}
> > +
> > +void sdhci_be32bs_writel(struct sdhci_host *host, u32 val, int reg)
> > +{
> > +	out_be32(host->ioaddr + reg, val);
> > +}
> > +
> > +void sdhci_be32bs_writew(struct sdhci_host *host, u16 val, int reg)
> > +{
> > +	struct sdhci_pltfm_host *pltfm_host = sdhci_priv(host);
> > +	int base = reg & ~0x3;
> > +	int shift = (reg & 0x2) * 8;
> > +
> > +	switch (reg) {
> > +	case SDHCI_TRANSFER_MODE:
> > +		/*
> > +		 * Postpone this write, we must do it together with a
> > +		 * command write that is down below.
> > +		 */
> > +		pltfm_host->xfer_mode_shadow = val;
> > +		return;
> > +	case SDHCI_COMMAND:
> > +		sdhci_be32bs_writel(host, val << 16 | pltfm_host->xfer_mode_shadow,
> > +				    SDHCI_TRANSFER_MODE);
> > +		return;
> > +	}
> > +	clrsetbits_be32(host->ioaddr + base, 0xffff << shift, val << shift);
> > +}
> > +
> > +void sdhci_be32bs_writeb(struct sdhci_host *host, u8 val, int reg)
> > +{
> > +	int base = reg & ~0x3;
> > +	int shift = (reg & 0x3) * 8;
> > +
> > +	clrsetbits_be32(host->ioaddr + base , 0xff << shift, val << shift);
> > +}
> > +#endif /* CONFIG_MMC_SDHCI_BIG_ENDIAN_32BIT_BYTE_SWAPPER */
> 
> I noticed you're very careful wrt copyright/authorship notices,
> except for this case. How about retaining copyright stuff when
> you merge these two files?
> 
Obviously, need to be more careful.  Will add.  Thanks.

-- 
Regards,
Shawn



More information about the Linuxppc-dev mailing list