[PATCH v10 10/10] USB ppc4xx: Add Synopsys DWC OTG driver kernel configuration and Makefile

[Sergei Shtylyov]

Hello.

On 28-03-2011 22:28, tmarri at apm.com wrote:

> From: Tirumala Marri <tmarri at apm.com>

> Add Synopsys DesignWare HS USB OTG driver kernel configuration.
> Synopsys OTG driver may operate in  host only, device only, or OTG mode.
> The driver also allows user configure the core to use its internal DMA
> or Slave (PIO) mode.

> Signed-off-by: Tirumala R Marri <tmarri at apm.com>
> Signed-off-by: Fushen Chen <fchen at apm.com>
> Signed-off-by: Mark Miesfeld <mmiesfeld at apm.com>

    This patch should precede patch 9 as patch 9 uses config. options defined 
here.

> diff --git a/drivers/usb/otg/dwc/Kconfig b/drivers/usb/otg/dwc/Kconfig
> new file mode 100644
> index 0000000..a8f22cb
> --- /dev/null
> +++ b/drivers/usb/otg/dwc/Kconfig
> @@ -0,0 +1,88 @@
> +#
> +# USB Dual Role (OTG-ready) Controller Drivers
> +# for silicon based on Synopsys DesignWare IP
> +#
[...]
> +# enable peripheral support (including with OTG)
> +config USB_GADGET_DWC_HDRC
> +	bool
> +	depends on USB_DWC_OTG && (DWC_DEVICE_ONLY || USB_DWC_OTG)

    Haven't we just defined this in patch 9? Redefinition of options isn't 
correct.

> +config DWC_OTG_REG_LE
> +	bool "DWC Little Endian Register"

    This should preferrably be passed via the platform data, I think.

> +	depends on USB_DWC_OTG
> +	default y
> +	help
> +	  OTG core register access is Little-Endian.
> +
> +config DWC_OTG_FIFO_LE
> +	bool "DWC FIFO Little Endian"

    This too.

> +	depends on USB_DWC_OTG
> +	default n

    "default n" not needed.

> +	help
> +	  OTG core FIFO access is Little-Endian.

    Little endian registers and big endian FIFO by default?

> +
> +config DWC_LIMITED_XFER_SIZE
> +	bool "DWC Endpoint Limited Xfer Size"
> +	depends on USB_GADGET_DWC_HDRC
> +	default n

    Not needed.

> +	help
> +	  Bit fields in the Device EP Transfer Size Register is 11 bits.

WBR, Sergei