[PATCH] powerpc/85xx: Add p2040 RDB board support

[Kumar Gala]

On Jun 28, 2011, at 2:52 AM, Mingkai Hu wrote:

> P2040RDB Specification:
> -----------------------
> 2Gbyte unbuffered DDR3 SDRAM SO-DIMM(64bit bus)
> 128 Mbyte NOR flash single-chip memory
> 256 Kbit M24256 I2C EEPROM
> 16 Mbyte SPI memory
> SD connector to interface with the SD memory card
> dTSEC1: connected to the Vitesse SGMII PHY (VSC8221)
> dTSEC2: connected to the Vitesse SGMII PHY (VSC8221)
> dTSEC3: connected to the Vitesse SGMII PHY (VSC8221)
> dTSEC4: connected to the Vitesse RGMII PHY (VSC8641)
> dTSEC5: connected to the Vitesse RGMII PHY (VSC8641)
> I2C1: Real time clock, Temperature sensor
> I2C2: Vcore Regulator, 256Kbit I2C Bus EEPROM
> SATA: Lanes C and Land D of Bank2 are connected to two SATA connectors
> UART: supports two UARTs up to 115200 bps for console
> USB 2.0: connected via a internal UTMI PHY to two TYPE-A interfaces
> PCIe:
> - Lanes E, F, G and H of Bank1 are connected to one x4 PCIe SLOT1
> - Lanes C and Land D of Bank2 are connected to one x4 PCIe SLOT2
> 
> Signed-off-by: Mingkai Hu <Mingkai.hu at freescale.com>
> ---
> Based on http://git.kernel.org/pub/scm/linux/kernel/git/galak/powerpc.git
> 
> arch/powerpc/boot/dts/p2040rdb.dts           |  166 +++++++
> arch/powerpc/boot/dts/p2040si.dtsi           |  623 ++++++++++++++++++++++++++
> arch/powerpc/configs/corenet32_smp_defconfig |    1 +
> arch/powerpc/platforms/85xx/Kconfig          |   12 +
> arch/powerpc/platforms/85xx/Makefile         |    1 +
> arch/powerpc/platforms/85xx/p2040_rdb.c      |   88 ++++
> 6 files changed, 891 insertions(+), 0 deletions(-)
> create mode 100644 arch/powerpc/boot/dts/p2040rdb.dts
> create mode 100644 arch/powerpc/boot/dts/p2040si.dtsi
> create mode 100644 arch/powerpc/platforms/85xx/p2040_rdb.c

applied to next

- k