fsl-esdhc on P2020 weird endianess behavior

[Elie De Brauwer]

Hello list,

I have a P2020 processor on a custom board which uses the embedded 
fsl-esdhc controller. Hardware-wise this is functional and in u-boot 
everything seems to behave (mmc part 0 gives the correct partition table 
and ext2ls/fatls are capable of reading the contents of the sd card).

However as soon as I start Linux (2.6.36), I get all sorts of unwanted 
behavior. Linux is unable to detect the partition layout (but if I do a 
hexdump of the MBR, I see the endianness is swapped (last 4 bytes are aa 
55 00 00). Also when I try to obtain the card registers they show the 
same behavior:
# cat ./devices/soc.0/ff72e000.sdhci/mmc_host/mmc0/mmc0:0001/scr
0000b50200000000

While for comparison the same value on my (x86) laptop gives:
edb at lapedb:/sys/devices/pci0000:00/0000:00:1e.0/0000:15:00.2/mmc_host/mmc0/mmc0:0001$ 
cat scr
02b5000000000000

In my config I have the following set:
CONFIG_MMC_SDHCI=y
CONFIG_MMC_SDHCI_IO_ACCESSORS=y
CONFIG_MMC_SDHCI_BIG_ENDIAN_32BIT_BYTE_SWAPPER=y
# CONFIG_MMC_SDHCI_PCI is not set
CONFIG_MMC_SDHCI_OF=y
CONFIG_MMC_SDHCI_OF_ESDHC=y


any pointers are welcome.

gr
E.

-- 
Elie De Brauwer