[PATCH v3] mtd/nand : workaround for Freescale FCM to support large-page Nand chip

[LiuShuo]

于 2011年08月19日 00:25, Scott Wood 写道:
> On 08/17/2011 09:33 PM, b35362 at freescale.com wrote:
>> From: Liu Shuo<b35362 at freescale.com>
>>
>> Freescale FCM controller has a 2K size limitation of buffer RAM. In order
>> to support the Nand flash chip whose page size is larger than 2K bytes,
>> we divide a page into multi-2K pages for MTD layer driver. In that case,
>> we force to set the page size to 2K bytes. We convert the page address of
>> MTD layer driver to a real page address in flash chips and a column index
>> in fsl_elbc driver. We can issue any column address by UA instruction of
>> elbc controller.
>>
>> NOTE: Due to there is a limitation of 'Number of Partial Program Cycles in
>> the Same Page (NOP)', the flash chip which is supported by this workaround
>> have to meet below conditions.
>> 	1. page size is not greater than 4KB
>> 	2.	1) if main area and spare area have independent NOPs:
>> 			  main  area NOP    :>=3
>> 			  spare area NOP    :>=2?
> How often are the NOPs split like this?
>
>> 		2) if main area and spare area have a common NOP:
>> 			  NOP               :>=4
> This depends on how the flash is used.  If you treat it as a NOP1 flash
> (e.g. run ubifs rather than jffs2), then you need NOP2 for a 4K chip and
> NOP4 for an 8K chip.  OTOH, if you would be making full use of NOP4 on a
> real 2K chip, you'll need NOP8 for a 4K chip.
>
> The NOP restrictions should be documented in the code itself, not just
> in the git changelog.  Maybe print it to the console when this hack is
> used, along with the NOP value read from the ID.

We can't read the NOP from the ID on any chip. Some chips don't
give this infomation.(e.g. Micron MT29F4G08BAC)

So it is hard to determine whether the probe() should fail in the code.
Maybe we will always print the NOP restrictions when this hack is used,
let the customers select how to use the flash on their board.

-LiuShuo
> If it's less than 4
> for 4K or 8 for 8K, also print a message saying not to use jffs2 (does
> yaffs2 do similar things?).  If it's less than 2 for 4K or 4 for 8K, the
> probe should fail.
>
> -Scott