[PATCH 1/4][v2] powerpc: add e500 HID1 bit definition

[Shaohui Xie]

From: Li Yang <leoli at freescale.com>

Also make 74xx HID1 definition conditional.

Signed-off-by: Li Yang <leoli at freescale.com>
Signed-off-by: Shaohui Xie <b21989 at freescale.com>
Cc: Li Yang <leoli at freescale.com>
Cc: Kumar Gala <kumar.gala at freescale.com>
Cc: Roy Zang <tie-fei.zang at freescale.com>
Cc: Alexandre Bounine <alexandre.bounine at idt.com>
---
 arch/powerpc/include/asm/reg.h       |    2 ++
 arch/powerpc/include/asm/reg_booke.h |   14 ++++++++++++++
 2 files changed, 16 insertions(+), 0 deletions(-)

diff --git a/arch/powerpc/include/asm/reg.h b/arch/powerpc/include/asm/reg.h
index ff0005e..125fc1a 100644
--- a/arch/powerpc/include/asm/reg.h
+++ b/arch/powerpc/include/asm/reg.h
@@ -283,6 +283,7 @@
 #define HID0_NOPTI	(1<<0)		/* No-op dcbt and dcbst instr. */
 
 #define SPRN_HID1	0x3F1		/* Hardware Implementation Register 1 */
+#ifdef CONFIG_6xx
 #define HID1_EMCP	(1<<31)		/* 7450 Machine Check Pin Enable */
 #define HID1_DFS	(1<<22)		/* 7447A Dynamic Frequency Scaling */
 #define HID1_PC0	(1<<16)		/* 7450 PLL_CFG[0] */
@@ -292,6 +293,7 @@
 #define HID1_SYNCBE	(1<<11)		/* 7450 ABE for sync, eieio */
 #define HID1_ABE	(1<<10)		/* 7450 Address Broadcast Enable */
 #define HID1_PS		(1<<16)		/* 750FX PLL selection */
+#endif
 #define SPRN_HID2	0x3F8		/* Hardware Implementation Register 2 */
 #define SPRN_HID2_GEKKO	0x398		/* Gekko HID2 Register */
 #define SPRN_IABR	0x3F2	/* Instruction Address Breakpoint Register */
diff --git a/arch/powerpc/include/asm/reg_booke.h b/arch/powerpc/include/asm/reg_booke.h
index 667a498..dc6adff 100644
--- a/arch/powerpc/include/asm/reg_booke.h
+++ b/arch/powerpc/include/asm/reg_booke.h
@@ -246,6 +246,20 @@
 					store or cache line push */
 #endif
 
+/* Bit definitions for the HID1 */
+#ifdef CONFIG_E500
+/* e500v1/v2 */
+#define HID1_PLL_CFG_MASK 0xfc000000	/* PLL_CFG input pins */
+#define HID1_RFXE	0x00020000	/* Read fault exception enable */
+#define HID1_R1DPE	0x00008000	/* R1 data bus parity enable */
+#define HID1_R2DPE	0x00004000	/* R2 data bus parity enable */
+#define HID1_ASTME	0x00002000	/* Address bus streaming mode enable */
+#define HID1_ABE	0x00001000	/* Address broadcast enable */
+#define HID1_MPXTT	0x00000400	/* MPX re-map transfer type */
+#define HID1_ATS	0x00000080	/* Atomic status */
+#define HID1_MID_MASK	0x0000000f	/* MID input pins */
+#endif
+
 /* Bit definitions for the DBSR. */
 /*
  * DBSR bits which have conflicting definitions on true Book E versus IBM 40x.
-- 
1.6.4