[PATCH 2/2] powerpc/mpc5121: add initial support for PDM360NG board

[Anatolij Gustschin]

Hi Grant,

On Sun, 2 May 2010 08:54:26 -0600
Grant Likely <grant.likely at secretlab.ca> wrote:

> Hi Anatolij,
> 
> Comments below.
> 
> On Fri, Apr 30, 2010 at 2:30 PM, Anatolij Gustschin <agust at denx.de> wrote:
> > Adds IFM PDM360NG device tree, and platform code.

...
> > +       nfc at 40000000 {
> > +               compatible = "fsl,mpc5121-nfc";
> > +               reg = <0x40000000 0x100000>;
> > +               interrupts = <0x6 0x8>;
> > +               interrupt-parent = <0x1>;
> 
> This looks wrong.  Shouldn't this be interrupt-parent = <&ipic>?  In
> fact, if the root node has interrupt-parent = <&ipic> then the
> interrupt-parent property can be omitted from all other nodes unless
> they need to override it.

Yes, it should be interrupt-parent = <&ipic>. I will fix it, thanks.

...
> > +               // IPIC
> > +               // interrupts cell = <intr #, sense>
> > +               // sense values match linux IORESOURCE_IRQ_* defines:
> > +               // sense == 8: Level, low assertion
> > +               // sense == 2: Edge, high-to-low change
> > +               //
> > +               ipic: interrupt-controller at c00 {
> > +                       compatible = "fsl,mpc5121-ipic", "fsl,ipic";
> > +                       interrupt-controller;
> > +                       #address-cells = <0>;
> 
> Don't need #address-cells here

Ok, will remove.

...
> > +               mdio at 2800 {
> > +                       compatible = "fsl,mpc5121-fec-mdio";
> > +                       reg = <0x2800 0x200>;
> > +                       #address-cells = <1>;
> > +                       #size-cells = <0>;
> > +                       phy: ethernet-phy at 0 {
> > +                               reg = <0x1f>;
> > +                               device_type = "ethernet-phy";
> 
> Remove device_type

Ok.

> > +               ethernet at 2800 {
> > +                       device_type = "network";
> 
> Ditto

Removing this property results in not functional ethernet,
in particular, the MAC address won't be set by U-Boot. I need
to add aliases node for ethernet0 to fix this. Ok, will remove
this device_type, too.

Thanks,
Anatolij