[PATCH 09/37] drivers/atm: use .dev.of_node instead of .node in struct of_device
Grant Likely
grant.likely at secretlab.ca
Fri Mar 12 05:04:37 EST 2010
.node is being removed
Signed-off-by: Grant Likely <grant.likely at secretlab.ca>
---
drivers/atm/fore200e.c | 16 +++++++++-------
1 files changed, 9 insertions(+), 7 deletions(-)
diff --git a/drivers/atm/fore200e.c b/drivers/atm/fore200e.c
index f7d6eba..593a03a 100644
--- a/drivers/atm/fore200e.c
+++ b/drivers/atm/fore200e.c
@@ -789,7 +789,7 @@ static int __init fore200e_sba_map(struct fore200e *fore200e)
fore200e->bus->write(0x02, fore200e->regs.sba.isr); /* XXX hardwired interrupt level */
/* get the supported DVMA burst sizes */
- bursts = of_getintprop_default(op->node->parent, "burst-sizes", 0x00);
+ bursts = of_getintprop_default(op->dev.of_node->parent, "burst-sizes", 0x00);
if (sbus_can_dma_64bit())
sbus_set_sbus64(&op->dev, bursts);
@@ -820,18 +820,20 @@ static int __init fore200e_sba_prom_read(struct fore200e *fore200e, struct prom_
const u8 *prop;
int len;
- prop = of_get_property(op->node, "madaddrlo2", &len);
+ prop = of_get_property(op->dev.of_node, "madaddrlo2", &len);
if (!prop)
return -ENODEV;
memcpy(&prom->mac_addr[4], prop, 4);
- prop = of_get_property(op->node, "madaddrhi4", &len);
+ prop = of_get_property(op->dev.of_node, "madaddrhi4", &len);
if (!prop)
return -ENODEV;
memcpy(&prom->mac_addr[2], prop, 4);
- prom->serial_number = of_getintprop_default(op->node, "serialnumber", 0);
- prom->hw_revision = of_getintprop_default(op->node, "promversion", 0);
+ prom->serial_number = of_getintprop_default(op->dev.of_node,
+ "serialnumber", 0);
+ prom->hw_revision = of_getintprop_default(op->dev.of_node,
+ "promversion", 0);
return 0;
}
@@ -841,10 +843,10 @@ static int fore200e_sba_proc_read(struct fore200e *fore200e, char *page)
struct of_device *op = fore200e->bus_dev;
const struct linux_prom_registers *regs;
- regs = of_get_property(op->node, "reg", NULL);
+ regs = of_get_property(op->dev.of_node, "reg", NULL);
return sprintf(page, " SBUS slot/device:\t\t%d/'%s'\n",
- (regs ? regs->which_io : 0), op->node->name);
+ (regs ? regs->which_io : 0), op->dev.of_node->name);
}
#endif /* CONFIG_SBUS */
More information about the Linuxppc-dev
mailing list