Freescale MPC5554 device tree (was: cross-compiling Linux for PowerPC e200 core?)

[David Gibson]

On Thu, Mar 11, 2010 at 07:11:56AM +0100, Németh Márton wrote:
[snip]
> +/dts-v1/;
> +
> +/ {
> +	model = "MPC5554";
> +	compatible = "fsl,MPC5554EVB";		// Freescale MPC5554 Evaluation Board
> +	#address-cells = <1>;
> +	#size-cells = <1>;
> +
> +	cpus {
> +		#address-cells = <1>;
> +		#size-cells = <0>;
> +
> +		PowerPC,5554 at 0 {

Modern best practice is to have the cpu nodes named just "cpu at XXX",
and put the PowerPC,NNNN into the compatible property.

> +			device_type = "cpu";
> +			reg = <0>;
> +			d-cache-line-size = <32>;
> +			i-cache-line-size = <32>;
> +			d-cache-size = <0x8000>;	// L1, 32KiB
> +			i-cache-size = <0x8000>;	// L1, 32KiB
> +			timebase-frequency = <0>;	// from bootloader
> +			bus-frequency = <0>;		// from bootloader
> +			clock-frequency = <0>;		// from bootloader
> +		};
> +	};
> +
> +	memory at 40000000 {
> +		device_type = "memory";
> +		reg = <0x40000000 0x10000>;	// 32KiB internal SRAM
> +	};
> +
> +	xbar at 1ff04000 {		// System Bus Crossbar Switch (XBAR)
> +		compatible = "fsl,mpc5554-xbar";
> +		#address-cells = <1>;
> +		#size-cells = <1>;
> +		// The full memory range is covered by XBAR
> +//		ranges = <0 0x00000000 0x100000000>;

If you want all addresses to be translated by the bus you need an
empty ranges property, not *no* ranges property.  No ranges property
indicates that addresses cannot be directly translated across the
bridge, which is not, I think, what you intend.

> +		reg = <0xfff04000 0x4000>;

The unit address '@1ff04000' does not match your reg property 0xfff04000.

> +
> +		flash at 00000000 {	// read-only FLASH

Unit addresses are not 0 padded, so this should be just 'flash at 0'.

> +			compatible = "fsl,mpc5554-flash";
> +			reg = <0x00000000 0x200000>;	// 2MiB internal FLASH
> +		};
> +
> +		bridge at c0000000 {
> +			compatible = "fsl,mpc5554-pbridge-a";
> +			#address-cells = <1>;
> +			#size-cells = <1>;
> +			ranges = <0 0xc0000000 0x20000000>;
> +			reg = <0xc3f00000 0x4000>;

The unit address is based on 'reg' (if present) not ranges, so it
should be bridge at c3f00000.  Likewise for the other bridge below.

-- 
David Gibson			| I'll have my music baroque, and my code
david AT gibson.dropbear.id.au	| minimalist, thank you.  NOT _the_ _other_
				| _way_ _around_!
http://www.ozlabs.org/~dgibson