fsl upm NAND Flash issue without GPIO chip handler

[Scott Wood]

nanda wrote:
> my response inlined..
> 
> On Tue, 19 Jan 2010 22:41:25 +0530 wrote
>  >nanda wrote:
>  >
>  > We had merged the 2.6.24
> 
> That's pretty old...
>  >> We were using 2.6.24 as this kernel version this is the references 
> used by us for MPC8321E.
>  > with the FSL based NAND driver,
> 
> Which one? Which chip are you using, and how is NAND attached to it?
>  >> MPC8321E processor connected to STM NAND Flash. Port C PIN 15 of the 
> processor connected to the R/B# ( Ready/Busy PIN) of the STM NAND Flash.

And the other pins are connected to the local bus controller via UPM?

This is supported in the upstream kernel by drivers/mtd/nand/fsl_upm.c, 
if there's nothing else keeping you on the BSP kernel.

>  > we observed that gpio library is mandatory to be included. We have 
> not included the
>  > gpios configured in the dts file as the we don’t have the separate GPIO
>  > chip(arch/powepc/boot/dts/board.dts).
> 
> What separate GPIO chip? Which "board.dts" are you looking at?
>  >> dts file I was refering is mpc832x_rdb.dts file, which we assumed 
> that GPIO controller is not required. ( Correct me if my assumption is 
> correct)

The only gpio controller in that dts file is the SoC's GPIO block (not a 
separate "GPIO chip").  Specifically, it's port D; you'll want to add a 
node for port C.

>  > After executing the image in the board, we observed the below
>  > 1) The device ID and manufacture Id was printed as "c0" and "c0" and the
>  > error message "No NAND device found!!!". Does it mean it is not
>  > accessing the NAND flash and the values read are junk one?
>  > 2) Processor of the board doesn’t connect the Ready/Busy of the NAND
>  > flash through the separate GPIO chip. I mean it is directly connected
>  > from GPIO Port C of PIN 15 to the Ready/Busy PIN of the NAND flash.
>  > Hence is it necessary to port the gpio specific functions like
>  > gpio_request/gpio_free(specified in fsl_upm.c file), instead should we
>  > need to configure the PIN par_io_config_pin() for configuration of the
>  > PORT C with 15th PIN and set the data value using par_io_data_set()
>  > (specified arch/powerpc/sysdev/qe_lib/qe_io.c)
> 
> Have you tried pointing the "gpios" property at pin 15 of port C? The
> whole point of this abstraction is that these connections are described
> in the data, not in the code.
>  >> Iam not sure how to specify the in the mpc832x_rdb.dts for the pin 
> 15 port C of the MPc8321E processor.

It should look like port B/E in the 836x_rdk dts, except you want reg to 
point at the port C registers.

For details, see the following binding documents: 
Documentation/powerpc/dts-bindings/gpio/gpio.txt
Documentation/powerpc/dts-bindings/fsl/cpm_qe/qe/par_io.txt
Documentation/powerpc/dts-bindings/fsl/upm-nand.txt

-Scott