PCI on 834x

[Gary Thomas]

On 02/25/2010 02:03 PM, Scott Wood wrote:
> Benjamin Herrenschmidt wrote:
>> On Thu, 2010-02-25 at 07:25 -0700, Gary Thomas wrote:
>>> I may have been too hasty pronouncing this fixed. Indeed, the
>>> SATA interface now works, but my video card (Fujitsu Coral-P)
>>> does not work when it's mapped at the bottom of the PCI space :-(
>>>
>>> With the bridge mapped, the video ends up at a non-zero address
>>> (0xC8000000..0xCFFFFFFF). If it gets mapped to 0xC0000000, it
>>> fails to respond to MMIO accesses.
>>>
>>> Any ideas how I might get around this? Is there a way to force
>>> the PCI allocator to start somewhere other than [relative] zero?
>>
>> I'm not familiar with the way the FSL bridge works, but it would
>> be possible to invert MMIO and DMA on your PCI bus. IE. Have MMIO go
>> from 0....2G and DMA from 2G..4G for example. Provided the FSL bridge
>> can offset the DMA back down to 0 (memory). Can it ?
>
> It can, but I don't see how that would help, if the problem is that the video card doesn't like the low 30 bits of its MMIO address being zero.
>
> Gary, can you check that the MMIO addresses are going to the PCI bus as-is, and aren't being translated down to zero? I.e. POTARn should equal POBARn, and likewise in the device
> tree's pci node's ranges.

Hmm, that doesn't match with how I've always had this setup.  I have:
   POTAR0 = 0x00000000
   POTBR0 = 0x000C0000        (0xC0000000 >> 12)

My device tree mappings are:
   ranges = <0x02000000 0x0 0xC0000000 0xC0000000 0x0 0x10000000
             0x01000000 0x0 0x00000000 0xB8000000 0x0 0x00100000>

n.b. I don't run U-Boot on these platforms (being the author
of RedBoot and all... :-)

-- 
------------------------------------------------------------
Gary Thomas                 |  Consulting for the
MLB Associates              |    Embedded world
------------------------------------------------------------