[PATCH] powerpc: Set a smaller value for RECLAIM_DISTANCE to enable zone reclaim

[Christoph Lameter]

On Fri, 19 Feb 2010, Mel Gorman wrote:

> > > The patch below sets a smaller value for RECLAIM_DISTANCE and thus enables
> > > zone reclaim.
> >
>
> I've no problem with the patch anyway.

Nor do I.

> > - We seem to end up racing between zone_watermark_ok, zone_reclaim and
> >   buffered_rmqueue. Since everyone is in here the memory one thread reclaims
> >   may be stolen by another thread.
> >
>
> You're pretty much on the button here. Only one thread at a time enters
> zone_reclaim. The others back off and try the next zone in the zonelist
> instead. I'm not sure what the original intention was but most likely it
> was to prevent too many parallel reclaimers in the same zone potentially
> dumping out way more data than necessary.

Yes it was to prevent concurrency slowing down reclaim. At that time the
number of processors per NUMA node was 2 or so. The number of pages that
are reclaimed is limited to avoid tossing too many page cache pages.

> You could experiment with waiting on the bit if the GFP flags allowi it? The
> expectation would be that the reclaim operation does not take long. Wait
> on the bit, if you are making the forward progress, recheck the
> watermarks before continueing.

You could reclaim more pages during a zone reclaim pass? Increase the
nr_to_reclaim in __zone_reclaim() and see if that helps. One zone reclaim
pass should reclaim enough local pages to keep the processors on a node
happy for a reasonable interval. Maybe do a fraction of a zone? 1/16th?