[PATCH] eSPI: change the read behavior of the SPIRF

[Grant Likely]

On Wed, Dec 01, 2010 at 05:29:18PM +0800, Mingkai Hu wrote:
> The user must read N bytes of SPIRF (1 <= N <= 4) that do not exceed the
> amount of data in the receive FIFO, so read the SPIRF byte by byte when
> the data in receive FIFO is less than 4 bytes.
> 
> On Simics, when read N bytes that exceed the amout of data in receive
> FIFO, we can't read the data out, that is we can't clear the rx FIFO,
> then the CPU will loop on the espi rx interrupt.
> 
> Signed-off-by: Mingkai Hu <Mingkai.hu at freescale.com>

Applied for -next, thanks.

g.

> ---
>  drivers/spi/spi_fsl_espi.c |   19 ++++++++++++++++---
>  1 files changed, 16 insertions(+), 3 deletions(-)
> 
> diff --git a/drivers/spi/spi_fsl_espi.c b/drivers/spi/spi_fsl_espi.c
> index e3b4f64..ae78926 100644
> --- a/drivers/spi/spi_fsl_espi.c
> +++ b/drivers/spi/spi_fsl_espi.c
> @@ -507,16 +507,29 @@ void fsl_espi_cpu_irq(struct mpc8xxx_spi *mspi, u32 events)
>  
>  	/* We need handle RX first */
>  	if (events & SPIE_NE) {
> -		u32 rx_data;
> +		u32 rx_data, tmp;
> +		u8 rx_data_8;
>  
>  		/* Spin until RX is done */
>  		while (SPIE_RXCNT(events) < min(4, mspi->len)) {
>  			cpu_relax();
>  			events = mpc8xxx_spi_read_reg(&reg_base->event);
>  		}
> -		mspi->len -= 4;
>  
> -		rx_data = mpc8xxx_spi_read_reg(&reg_base->receive);
> +		if (mspi->len >= 4) {
> +			rx_data = mpc8xxx_spi_read_reg(&reg_base->receive);
> +		} else {
> +			tmp = mspi->len;
> +			rx_data = 0;
> +			while (tmp--) {
> +				rx_data_8 = in_8((u8 *)&reg_base->receive);
> +				rx_data |= (rx_data_8 << (tmp * 8));
> +			}
> +
> +			rx_data <<= (4 - mspi->len) * 8;
> +		}
> +
> +		mspi->len -= 4;
>  
>  		if (mspi->rx)
>  			mspi->get_rx(rx_data, mspi);
> -- 
> 1.7.0.4
> 
>