make 3.82 fails on powerpc defconfig update [was: Linux 2.6.35]

[Sam Ravnborg]

> 
> Thanks, this seems to fix the first issue, but then I get the same erro on the following line 190:
> 
> 190: bootwrapper_install %.dtb:
> 191:        $(Q)$(MAKE) ARCH=ppc64 $(build)=$(boot) $(patsubst %,$(boot)/%,$@)
> 

Obviously - dunno how I missed that.
Updated patch below.

I will do a proper submission after you
confirm that powerpc build is working with make 3.82.

	Sam

diff --git a/arch/powerpc/Makefile b/arch/powerpc/Makefile
index 77cfe7a..ace7a3e 100644
--- a/arch/powerpc/Makefile
+++ b/arch/powerpc/Makefile
@@ -163,9 +163,11 @@ drivers-$(CONFIG_OPROFILE)	+= arch/powerpc/oprofile/
 # Default to zImage, override when needed
 all: zImage
 
-BOOT_TARGETS = zImage zImage.initrd uImage zImage% dtbImage% treeImage.% cuImage.% simpleImage.%
+# With make 3.82 we cannot mix normal and wildcard targets
+BOOT_TARGETS1 := zImage zImage.initrd uImaged
+BOOT_TARGETS2 := zImage% dtbImage% treeImage.% cuImage.% simpleImage.%
 
-PHONY += $(BOOT_TARGETS)
+PHONY += $(BOOT_TARGETS1) $(BOOT_TARGETS2)
 
 boot := arch/$(ARCH)/boot
 
@@ -180,10 +182,16 @@ relocs_check: arch/powerpc/relocs_check.pl vmlinux
 zImage: relocs_check
 endif
 
-$(BOOT_TARGETS): vmlinux
+$(BOOT_TARGETS1): vmlinux
+	$(Q)$(MAKE) ARCH=ppc64 $(build)=$(boot) $(patsubst %,$(boot)/%,$@)
+$(BOOT_TARGETS2): vmlinux
+	$(Q)$(MAKE) ARCH=ppc64 $(build)=$(boot) $(patsubst %,$(boot)/%,$@)
+
+
+bootwrapper_install
 	$(Q)$(MAKE) ARCH=ppc64 $(build)=$(boot) $(patsubst %,$(boot)/%,$@)
 
-bootwrapper_install %.dtb:
+%.dtb:
 	$(Q)$(MAKE) ARCH=ppc64 $(build)=$(boot) $(patsubst %,$(boot)/%,$@)
 
 define archhelp