[PATCH v2 4/5] powerpc: NAND: FSL UPM: document new bindings

[Wolfgang Grandegger]

This patch adds documentation for the new NAND FSL UPM bindings for:

 NAND: FSL-UPM: add multi chip support
 NAND: FSL-UPM: Add wait flags to support board/chip specific delays
 NAND: FSL-UPM: add support for selecting chips via MAR

Signed-off-by: Wolfgang Grandegger <wg at grandegger.com>
---
 .../powerpc/dts-bindings/fsl/upm-nand.txt          |   42 +++++++++++++++++++-
 1 files changed, 40 insertions(+), 2 deletions(-)

diff --git a/Documentation/powerpc/dts-bindings/fsl/upm-nand.txt b/Documentation/powerpc/dts-bindings/fsl/upm-nand.txt
index 84a04d5..3919828 100644
--- a/Documentation/powerpc/dts-bindings/fsl/upm-nand.txt
+++ b/Documentation/powerpc/dts-bindings/fsl/upm-nand.txt
@@ -5,9 +5,24 @@ Required properties:
 - reg : should specify localbus chip select and size used for the chip.
 - fsl,upm-addr-offset : UPM pattern offset for the address latch.
 - fsl,upm-cmd-offset : UPM pattern offset for the command latch.
-- gpios : may specify optional GPIO connected to the Ready-Not-Busy pin.
 
-Example:
+Optional properties:
+- fsl,upm-mar-offset : use the UPM machine address register to drive a
+  		       custom chip select logic using the specified
+		       offset.
+- fsl,upm-wait-flags : add chip-dependent short delays after running the
+  		       UPM pattern (0x1), after writing a data byte (0x2)
+		       or after writing out a buffer (0x4).
+- gpios : may specify optional GPIOs connected to the Ready-Not-Busy pins
+	  (R/B#). For multi-chip devices, "num-chips" GPIO definitions are
+	  required.
+- chip-delay : chip dependent delay for transfering data from array to
+	       read registers (tR). Required if property "gpios" is not
+	       used (R/B# pins not connected).
+- num-chips : number of chips per device for multi-chip support.
+- chip-offset : address offset between chips for multi-chip support.
+
+Examples:
 
 upm at 1,0 {
 	compatible = "fsl,upm-nand";
@@ -26,3 +41,26 @@ upm at 1,0 {
 		};
 	};
 };
+
+upm at 3,0 {
+	compatible = "fsl,upm-nand";
+	reg = <3 0x0 0x800>;
+	fsl,upm-addr-offset = <0x10>;
+	fsl,upm-cmd-offset = <0x08>;
+	fsl,upm-wait-flags = <0x5>;
+	/* Multi-chip device */
+	fsl,upm-mar-chip-offset = <0x200>;
+	num-chips = <2>;
+	chip-offset = <0x200>;
+	chip-delay = <25>; // in micro-seconds
+
+	nand at 0 {
+		#address-cells = <1>;
+		#size-cells = <1>;
+
+		partition at 0 {
+			    label = "fs";
+			    reg = <0x00000000 0x10000000>;
+		};
+	};
+};
-- 
1.6.0.6