How to bring up fs_enet on 2.6.27?

[Scott Wood]

On Wed, Feb 25, 2009 at 06:09:32PM +1100, Daniel Ng wrote:
> On Fri, Feb 20, 2009 at 4:01 PM, Daniel Ng <daniel.ng1234 at gmail.com> wrote:
> >
> > Now, I'm seeing these boot messages:
> >
> > f0010d40:00 not found
> > eth0: Could not attach to PHY
> > IP-Config: Failed to open eth0
> > IP-Config: Device `eth0' not found.
> >
> > Previous mailing list discussions suggest that I use the correct PHY,
> > which I am sure about because my 8272-based board only has the one PHY
> > ie. PHY0 with reg = <0x0>.
> >
> > Note the relevant parts of my Device Tree below. Currently, our PHY
> > attributes eg. 'auto-negotiate' are not changeable, so we aren't
> > actually using MDC+MDIO even the MDC+MDIO lines exist.

Your device tree is telling the kernel that you *are* using those lines.  If
they're not connected the way the device tree describes them as being
connected, you'll have to replace it with something that accurately
describes your hardware.

> > Also, the PHY interrupt line is not wired up. Hence the PHY0 interrupts
> > field is <0 8> (or should it be removed altogether?).

If your PHY interrupt is not connected, then you must remove the
"interrupts" property altogether.  "0" is a potentially valid interrupt
number.

-Scott