[PATCH] ucc_geth: Fix half-duplex operation for non-MII/RMII interfaces

[Anton Vorontsov]

On Thu, Jun 25, 2009 at 11:02:36AM +0400, Anton Vorontsov wrote:
[...]
> Of course, it could be that the root cause of the problems
> I observe is weird NIC on my host. Well, then QA team should
> have used the same broken NIC on their hosts. :-)
> 
> I can easily test it by interconnecting two targets though.
[...]
> Definitely. Though I'm out of ideas if it's NOT host-side issue.

Two boards interconnected work fine. eTSEC + SKY2 NIC also work
OK. I'll test some more NICs, known to not work is 3Com
Corporation 3c905C-TX/TX-M [Tornado] (rev 74).


After some netperf tests, statistic on a gianfar board:

# ethtool -S eth0 | grep -v ": 0"
NIC statistics:
     rx-dropped-by-kernel: 2
     tx-rx-64-frames: 52
     tx-rx-65-127-frames: 20668
     tx-rx-128-255-frames: 10343
     tx-rx-256-511-frames: 113
     tx-rx-512-1023-frames: 147
     tx-rx-1024-1518-frames: 45965
     rx-bytes: 45075782
     rx-packets: 50300
     rx-carrier-sense-error: 1
     rx-fragmented-frames: 7600
     tx-byte-counter: 27401677
     tx-packets: 34618
     tx-broadcast-packets: 3
     tx-deferral-packets: 5
     tx-single-collision-packets: 4039
     tx-multiple-collision-packets: 1943
     tx-excessive-collision-packets: 30
     tx-total-collision: 785


Thanks for the ideas, Mark.

-- 
Anton Vorontsov
email: cbouatmailru at gmail.com
irc://irc.freenode.net/bd2