MPC83xx watchdog reset board dead lock

[Norbert van Bolhuis]

Hi Leon,

...

> Most designs do not care about the watchdog, or only pet in their
> non-critical paths... That's not what the watchdog is for.
> Also, I don't care about u-boot.
> 
> I care about a design where the Flash NOR could be in write mode at
> any time when the watchdog triggers, when the hardware is running
> critical software.
> No lifes in danger when it happens, only jobs, so no biggy :-)
> 


true, I was just looking from SW/u-boot perspective.
Ideally the dead-lock is prevented on board/HW level.


> 
> David has been helpful in thinking this through, but we followed-up
> offline, and we independently came up with the following design, so
> this must therefore work (disclaimer applies).
> 
> Note, it DOES require a NOR flash that has a RY/BUSY# pin.
> 
> Quoting David Hawkins, who gave a very clear explanation:
> ---
> How about using the RDY/BUSY# pin on the Flash in conjunction
> with PORESET#. If the flash is busy, then the processor gets
> PORESET#, otherwise, the HRESET# just does its normal thing.
> 
> That way PORESET# only ever asserts when you have the
> combo of the Flash being busy and HRESET# asserting.
> 
> <...>
> 
> If you have the Flash BUSY# signal, then this scheme works
> great, since using HRESET# low and BUSY# low to create a
> PORESET# source is only active until the Flash RESET#
> is asserted long enough for it to get out of the BUSY#
> state and back into read-array mode.
> ---
> 
> Kudos to David.
> 
> I'll be testing the design tomorrow on the reference board, I'll
> report results in this thread.
> 


Interesting.
Looking forward to the results.

---
N. van Bolhuis.