[PATCH v4] 83xx: add support for the kmeter1 board.

David Gibson david at gibson.dropbear.id.au
Fri Jun 12 11:13:32 EST 2009


On Thu, Jun 11, 2009 at 08:10:41PM +0200, Heiko Schocher wrote:
> The following series implements basic board support for
> the kmeter1 board from keymile, based on a MPC8360.

[snip]
> +		par_io at 1400 {
> +			reg = <0x1400 0x100>;
> +			device_type = "par_io";

This should have a compatible value instead of a device_type value.

[snip]

> +			num-ports = <7>;
> +
> +			pio_ucc1: ucc_pin at 00 {

Since these nodes have addresses, they should also have reg
properties.  And the parent should have #address-cells and
#size-cells.

[snip]
> +		qe at 100000 {
> +			#address-cells = <1>;
> +			#size-cells = <1>;
> +			device_type = "qe";

This device_type should not be here.

> +			compatible = "fsl,qe";
> +			ranges = <0x0 0x100000 0x100000>;
> +			reg = <0x100000 0x480>;
> +			clock-frequency = <0>;	/* Filled in by U-Boot */
> +			brg-frequency = <0>;	/* Filled in by U-Boot */
> +			bus-frequency = <0>;	/* Filled in by U-Boot */

-- 
David Gibson			| I'll have my music baroque, and my code
david AT gibson.dropbear.id.au	| minimalist, thank you.  NOT _the_ _other_
				| _way_ _around_!
http://www.ozlabs.org/~dgibson


More information about the Linuxppc-dev mailing list