MPC5200 PCI interrupt routing

[Juergen Beisert]

Benjamin,

On Mittwoch, 24. September 2008, Benjamin Herrenschmidt wrote:
> On Wed, 2008-09-24 at 12:15 -0600, Grant Likely wrote:
> > On Wed, Sep 24, 2008 at 05:16:34PM +0200, Juergen Beisert wrote:
> > > On Dienstag, 23. September 2008, Juergen Beisert wrote:
> > > > What Kernel do you run on your target? On my hardware a 2.6.23 still
> > > > work as expected, but a 2.6.26 fails all the time.
> > >
> > > One should enable the internal USB clock. If done, it works... In
> > > 2.6.23 is was done in mpc52xx_common.c. It was removed in 2.6.24.
> >
> > It was removed because some 5200 platform do not use USB and should not
> > enable the internal clock.  In general, it is not the kernel's job to
> > configure clocking and pin usage on the chip.  Instead, it should be set
> > correctly at power up by U-Boot.
>
> Or by the USB host driver :-)

But how to deal with platform specific things like (in this case) unknown 
external clock or usage of the internal clock generator (= how to setup the 
frequency divider)?

> > However, if firmware *cannot* be changed, there is a workaround.
> > You can create a new platform specific board support file in
> > arch/powerpc/platforms/52xx/ that matches against your specific board
> > and performs the needed fixups.  An example of this is lite5200.c.  Many
> > lite5200 boards have older versions of U-Boot installed which does not
> > correctly configure clocks or port-config.  So, lite5200.c matches to
> > the board instead of mpc5200_simple.c so that the board specific fixups
> > can be performed easily.  You should do the same for your board.
>
> I tend to thing that drivers should deal with their own clocks.

ACK. But only to switch them on and off. Not to configure them.

> In fact it would be nice if one could stop the clocks while the host port is
> in suspend no ?

ACK.

Juergen

-- 
Dipl.-Ing. Juergen Beisert | http://www.pengutronix.de
 Pengutronix - Linux Solutions for Science and Industry
    Handelsregister: Amtsgericht Hildesheim, HRA 2686
         Vertretung Sued/Muenchen, Germany
   Phone: +49-8766-939 228 |  Fax: +49-5121-206917-9