[RFC PATCH 2/2 v2] powerpc/83xx: mpc836x_mds: add support for USBHost

[Anton Vorontsov]

On Thu, Sep 04, 2008 at 02:45:05PM +0800, Li Yang-R58472 wrote:
> > -----Original Message-----
> > From: Anton Vorontsov [mailto:avorontsov at ru.mvista.com] 
> > Sent: Monday, September 01, 2008 9:35 PM
> > To: Kumar Gala
> > Cc: linuxppc-dev at ozlabs.org; Li Yang-R58472
> > Subject: [RFC PATCH 2/2 v2] powerpc/83xx: mpc836x_mds: add 
> > support for USBHost
> > 
> > Various changes to support QE USB Host on a MPC8360E-MDS board:
> > 
> > - Update the device tree per QE USB bindings;
> > - Configure QE Par IO;
> > - Set up BCSR for both USB Host and Peripheral modes;
> > - Add timer (GTM) node;
> > - Add gpio-controller node for BCSR13 bank;
> > - Select FSL_GTM, QE_GPIO and OF_SIMPLE_GPIO.
> > 
> > The work is loosely based on Li Yang's patch[1], which is 
> > used to support peripheral mode only.
> > 
> > [1] http://ozlabs.org/pipermail/linuxppc-dev/2008-August/061357.html
> > 
> > The s-o-b line of the original patch preserved here.
> > 
> > Signed-off-by: Li Yang <leoli at freescale.com>
> > Signed-off-by: Anton Vorontsov <avorontsov at ru.mvista.com>
> 
> {snip}
> > @@ -297,11 +328,20 @@
> >  		};
> >  
> >  		usb at 6c0 {
> > -			compatible = "qe_udc";
> > +			compatible = "fsl,mpc8360-qe-usb",
> > +				     "fsl,mpc8323-qe-usb";
> >  			reg = <0x6c0 0x40 0x8b00 0x100>;
> >  			interrupts = <11>;
> >  			interrupt-parent = <&qeic>;
> > -			mode = "slave";
> > +			fsl,fullspeed-clock = "clk21";
> > +			fsl,lowspeed-clock = "brg9";
> > +			gpios = <&qe_pio_b  2 0   /* USBOE */
> > +				 &qe_pio_b  3 0   /* USBTP */
> > +				 &qe_pio_b  8 0   /* USBTN */
> > +				 &qe_pio_b  9 0   /* USBRP */
> > +				 &qe_pio_b 11 0   /* USBRN */
> > +				 &bcsr13    5 0   /* SPEED */
> > +				 &bcsr13    4 1>; /* POWER */
> 
> 
> Nothing against this node.  But I don't think gpio nodes can
> replaces par_io nodes. 

Yes, they can't, and gpios = <> are not meant to be replacement
for par_io nodes. gpios are used by the host driver, the driver
really needs these "gpios = <>" as gpios.

-- 
Anton Vorontsov
email: cbouatmailru at gmail.com
irc://irc.freenode.net/bd2