Problems with PCI-E devices not being detected with switch

[Benjamin Herrenschmidt]

On Thu, 2008-10-16 at 10:01 -0500, Ayman El-Khashab wrote:
> Benjamin Herrenschmidt wrote:
> > On Wed, 2008-10-15 at 10:47 -0500, Ayman El-Khashab wrote:
> > 
> > Note for people on CC: This is a problem on 460EX on a canyonland
> > using the 4x port. 
> > 
> >> The problem occurs when Linux boots. It sees the switch (and looking
> >> in /sys/bus/... confirms it), but nothing on the downstream sides of
> >> the switch (secondary busses) is visible.  There were no boot
> >> messages to indicate it had seen the Sil 3531 and it doesn't
> >> function.  We've also tried other PCI-E devices (NI GPIB) on the
> >> downstream side and they are also not detected, so it seems to be
> >> something in Linux, my configuration, etc.  I've included the boot
> >> messages below from u-boot and the kernel.  It is more than just the
> >> pci boot messages, but I was not sure if something else in the log
> >> with provide some insight. 
> > 
> > The messages below look really fishy indeed:

Ok, can you send me a full dmesg log with "debug" on the kernel command
line after adding a #define DEBUG 1 to the top of drivers/pci/probe.c
please ? (before the batch of #include).

The generic code is _supposed_ to somewhat figure out that bridges
haven't been setup by the firmware and fix that up, but for some reason
it's not happening I think. Or something else is wrong ...

Stefan, I could use the same log from your customer too.

Thanks,
Ben.