[PATCH] powerpc: make Freescale QE support a selectable Kconfig option

[Anton Vorontsov]

On Fri, Oct 03, 2008 at 02:58:57AM -0500, Kumar Gala wrote:
>
> On Oct 3, 2008, at 2:04 AM, Anton Vorontsov wrote:
>
>> On Thu, Oct 02, 2008 at 10:27:57AM -0500, Timur Tabi wrote:
>>> Modify the Kconfig so that Freescale QUICC Engine (QE) support is a  
>>> selectable
>>> option, thereby allowing users to compile kernels without any QE  
>>> support.
>>>
>>> The drawback is that QE support is now disabled by default on  
>>> platforms that
>>> have a QE, and so a defconfig is needed to enable QE and QE devices  
>>> (like
>>> UCC GETH).  Fortunately, all the current relevant defconfigs do that 
>>> already.
>>>
>>> Signed-off-by: Timur Tabi <timur at freescale.com>
>>> ---
>>
>> [...]
>>> config MPC836x_RDK
>>> 	bool "Freescale/Logic MPC836x RDK"
>>> 	select DEFAULT_UIMAGE
>>> -	select QUICC_ENGINE
>>> 	select QE_GPIO
>>
>> IIRC selects do not honor any dependencies, i.e. you should delete
>> the QE_GPIO too.
>
> Is QE_GPIO need by the board?  or you just enabled it to have it?

Well... This select is a relic from the time when we were discussing
how to register QE GPIOs: using board files or using a dedicated
arch_initcall. We seemed to agree on arch_initcall, but in the end
you applied 'board file' approach. ;-)

http://www.mail-archive.com/linuxppc-dev@ozlabs.org/msg19147.html

Later I sent you an update that eliminated the need of the QE_GPIO
select:

http://www.mail-archive.com/linuxppc-dev@ozlabs.org/msg19147.html

But nobody recalled to remove the 'select QE_GPIO' after that...

-- 
Anton Vorontsov
email: cbouatmailru at gmail.com
irc://irc.freenode.net/bd2