[RESEND][POWERPC] mpc5200: Amalgamated dts fixes and updates

[Grant Likely]

On Wed, Mar 26, 2008 at 1:45 PM, Bartlomiej Sieka <tur at semihalf.com> wrote:
>     The bulk of this patch is taken from
>     http://patchwork.ozlabs.org/linuxppc/patch?q=Balakowicz&id=16197, with few
>     other updates.
>
>     Signed-off-by: Marian Balakowicz <m8 at semihalf.com>
>  ---
>  Addressed comments from the list; would appreciate picking up as the patch
>  fixes booting issue on TQM5200 and Motion-PRO (cm5200 changes are analogous,
>  but not tested due to hardware unavailability).

I see one obvious error; but other than that it looks good.  Once that
is fixed I can recommend for Paul to pick it up for .25.  It's just
dts changes, so I don't expect it to be a problem.

Cheers,
g.

>  diff --git a/arch/powerpc/boot/dts/motionpro.dts b/arch/powerpc/boot/dts/motionpro.dts
>  index 76951ab..f27256b 100644
>  --- a/arch/powerpc/boot/dts/motionpro.dts
>  +++ b/arch/powerpc/boot/dts/motionpro.dts
>  @@ -209,10 +208,25 @@
>  +               mdio at 3000 {
>  +                       #address-cells = <1>;
>  +                       #size-cells = <0>;
>  +                       compatible = "fsl,mpc5200b-mdio","fsl,mpc5200-mdio";
>  +                       reg = <3000 400>;       // fec range, since we need to setup fec interrupts
>  +                       interrupts = <2 5 0>;   // these are for "mii command finished", not link changes & co.
>  +                       interrupt-parent = <&mpc5200_pic>;
>  +
>  +                       phy0:ethernet-phy at 0 {
>  +                               device_type = "ethernet-phy";
>  +                               reg = <2>;

This doesn't look right.  Reg should match the value in "ethernet-phy at 0"


-- 
Grant Likely, B.Sc., P.Eng.
Secret Lab Technologies Ltd.